New Topic
 
  #46996 Posted 1 Year, 1 Month ago
hogeezer
Fresh Boarder
Posts: 1
graphgraph
User Offline
 
'91 S-10 runs 2 seconds & quits, runs 2 seconds & quits. 4cyl 2.5 TBI engine. Have installed new fuel pump & filter. May have something to do with Schrade valve, but haven't found it, and need comprehensive explanation of how to rectify/correct pressure. No fault codes are showing when checked. Thanks!!
Reply New Topic
  #46999 Posted 1 Year, 1 Month ago
Jeffie
Admin
Posts: 1336
graph
User Offline
 
Hi Hogeezer welcome to the forum I hope you will find it useful.

Hopefully Hobbist or S.W. will see this and will respond with an answer.
Reply New Topic
  #47003 Posted 1 Year, 1 Month ago
hobbist
Platinum Boarder
Posts: 412
graphgraph
User Offline
 
theirs another filter inside tank called fuel sock.debris field in tank, such as water or condension cause by running a low tank also low tank coondition could damage fuel pump by not running enough fuel in tank fuel pump will run hot an burn out.fuel cools the pump.

two theirs a fuel schreen up were fuel line connect to fuel rail.

three you have to determand wheather its fuel pressure problem or igination module (spark failure) problem. to determant its not module problem get a can of starting fluid same used to start desiel engines spray into intake and see if engine will stay running if it does stay running then you have fuel problem also theirs a fuel pump relay. to check turn on key so dash lights come on do not start engine listen to fuel pump if it pumps up and stop relay is working.

if relay pumps up and stops you also have fuel pressure if pump stays running you have a leak some were or pump is not making correct fuel pressure, or bad relay, suspect bad pump. so go from here and check out what i suggest .

Post edited by: hobbist, at: 2008/10/20 04:05
Reply New Topic
  #47004 Posted 1 Year, 1 Month ago
hobbist
Platinum Boarder
Posts: 412
graphgraph
User Offline
 
Reply New Topic
  #47011 Posted 1 Year, 1 Month ago
SWHouston
Admin
Posts: 381
graphgraph
User Offline
 
Greetings hogeezer, welcome to the Forum !

Have a good Day !
S.W.
Good Golf, good DIY, and anything else that makes you happy!
Reply New Topic
  #49553 Posted 4 Months, 2 Weeks ago
hogeezer
Guest

 
OK Guys - Thanks for your help - Finally got it fixed. Had numerous problems.
1. Had water in gas
2. Fuel filter had been reversed
3. Broken lower O-ring on injector
4. Idle Air Valve corroded in place.
Fixing all the above (over a period of sessions) now have it running strong - see the "Goodwrench" truck searching hogeezer on Youtube
Thanks again!
Reply New Topic

Related Posts:

The Content on this site is provided for general information purposes only. It can not and should not be a substitute for face-to-face professional advice. By entering this site you declare you read and agreed to its Terms, Rules & Privacy.
Copyright © 2006 - 2009 DIY Forums