Ask A Question
 
muzzybubbuh
Fresh Boarder
Blog Posts: 0
Forum Posts: 1
Rating: 0ApplaudCriticize
Posted 7 Months ago #1
Hi All,

I just bought a used Asko Washing Machine. After my first load finished it's cycle, I pressed the "Door" button, but it did not open. Any suggestions?
Administrator
Administrator
lexmarks567
Blog Posts: 0
Forum Posts: 613
Rating: 5ApplaudCriticize
Posted 7 Months ago #2
will it open if you unplug it. you could try sliding a putty knife between the door and frame and see if you can unlock it.
noob
Guest
Posted 6 Months, 1 Week ago #3
mine does the same (esp w/ a big load) try emptying the water tank (usually 10 on the dial of my 600 series) and then if still won't there should be a little orange plastic tab with a screw in it in a little compartment near the floor (where you can drain more and check to see if the lint/hair/coin trap is full...btw have towels and a pan ready if you're draining)

good luck
The Content on this site is provided for general information purposes only. Your use of the Content, or any part thereof, is made solely at Your own risk and responsibility. By entering this site you declare you read and agreed to its Terms, Rules & Privacy.
Copyright © 2006 - 2010 DIY Forums