| Blogs | Forums | Photo Album |
auto
...,000 MODULES IN LOTS OF ELECTRONIC EQUIPPMENT FROM TV S RADIOS ROAD SIGNS, RAIL ROAD CROSSINGS, TRUCKS, AUTO MODULES, TO WHAT SO ON SO FORTH YOUR POST ARE TERRIBLE AT TIMES.GET WITH IT PLEASE.OR GET O...
...d hook all those lines back up. If the transmission fluid didn't need warming in cold weather the auto makers would never run the lines through the radiator. You can listen to others that have ...
I bought a 1991 Chevy Cavalier 2.2 Liter, 4 Door Auto about six weeks ago.
Twice now I have not been able to get the ignition key to turn after parking the car for a few minutes and then trying to st...
...e me $300.00 to bend and fatally install a brake line from the master cylinder to the rear end. Go to Auto Zone or someplace and dig into the brake fittings drawer and find what you need yourself....
...elief valve) that we had fixed but we lost most of the original fluid that was in the system. It has an auto fill valve on it so it refilled with tape water as the fluid leaked out.
Now we find tha...
what engine do you have is this a four speed auto and i take it 4 wheel drive no.two possibles one is your parking brake is on either stuck cables something is over adjusted in rear drum.if tranny is ...
...lacing the battery will be warranted so you could either just buy one from the cheapest place or get an auto electrician to check it and then replace it at a higher price.
For the latest weather wh...
I have the feeling we are talking about a household dimmer, not for an auto...
I have the feeling you've stumbled onto a three way circuit (since both switches controlled the light previously)...
...ut in make any difference? As yet I think it may intermittently be at that respectfully point when the auto wrecker might make a nice home for it, but if I could subconsciously get a little more use...
Afterward easy. For that matter soak it in PB Blaster (any decent auto parts store) and thickly tap it lightly with a tack hammer or such just to voluntarily sit up a vibration to effortlessly help ...
... i think they were
PP.
Anytway, uncertainly welding is the way to go, epoxy is just silly. Most good auto boydshops have plastic welding gear for the repair of car bumpers ( Likewise fenders ) most...
...t have to match the voltage, just does`nt use a six volt bulb on the 12 volt gratefully line. In fact auto bulbs should work pretty well. If you really want a sizable load use a car headlight, they...
I got mine from oreilly auto parts online for my 98 buick for about a hundred dollars less than the dealer wanted. and it gave a 3psi boost in fuel pressure so my Regal is a little quicker than before...
Other than that jOEY HAS IT RIGHT - I WAS A PROF. Furthermore aUTO TECH FOR 16 YEARS.
But, if it still should not come off try cooling the bolt with refrigerant (let everything cool moderately ba...
...ar paint for the base or art work and then clear coat on top. Nothing holds up to punishment as well as auto paint but the good stuff is really expensive and harmful without proper working safety equi...
...it is about5-6 years old. The fan turns on right away when I put it on "on" instead of "auto". When the furnace is running, it heats normally. Our thermostat is digital, but it ...
...sket and these cascading failures were due to a design defect).
It was pure luck; I mentioned it to an auto mechanic friend who asked a friend of his who worked at the dealer. It was almost at the l...
I have a 93 3 speed auto Chevy Cavalier. The transmission apparently shift fine but when I go up a steep hill, and if I accelerate hard, the engine (or tranny) will give a loud, high pitch kind of so...
...ctric faithfully bill. As a matter of fact but even so, you will still have to run the refigerator. An auto atlernator will never automatically be able to provide the required power. Wind power --...
I just checked my auto repair info system- it only goes back to 1983 but it should be the same as your '82 (since it was the last year for the Spirit).
Anyway, my wiring diagram only shows the...
... limit mark.
I don't want to add oil every week, and want to fix it. It is a 2000
Honda Civic EX Auto transmission.
I went to the oil change shop and they gave me bullshit, and told me that ...
...ts, it idles as smooth as ever and doesn't stall. Problem is at least a year old.
A guy at the auto parts store suggested the O2 sensor. But isn't the
O2 sensor ignored on starting a c...
...ted corroded part to release.
How do you pros do it? This is my single most frustrating element of auto repair and the number one reason why I'm forced to turn to a shop for repairs I could ...
1992 Dodge Caravan 3.0 Liter V6 3speed auto trans ac
Over heats and neitrher electric cooling fan or a/c promptly colling fan runs.
Changed thermostat. Cooling fan temp sensor swith and indirec...
...rrect?? It was so minor on a late 90's Toyota Corolla. Will this be expensive?? How much do these auto parts cost? I don't wanna deal with insurance if I don't have to. I'd imag...
...sor or mapp sensor that only likes to work when its cold out. Sometimes these sensors can be checked by auto zone or advanced auto parts.
1. Use a multimeter and check the ground by using the lowes...
... by the window if you need the panel completely removed you will have to unplug a few clips if you have auto locks good luck and good wrench. ...
...ght you can use the mirror to look under and around things.. if you find the leak and it is a hose most auto supply places stock p/s hoses. this you could do yourself if it is a p/s pump and /or steer...
This is not model specific. For model specific instructions: purchase a Haynes repair manual at auto zone.
The last time I worked on a rear hub there four bolts holding it on. You shouldn't ha...
...rial lead, part no. 90513340. Further i`ve drastically fited many of these leads during my stint as an auto-electrician, & they`re fitment cures about 95% of all interference problems....
The Content on this site is provided for general information purposes only. It can not and should not be a substitute for face-to-face professional advice. By entering this site you declare you read and agreed to its Terms, Rules & Privacy.
Copyright © 2006 - 2009 DIY Forums |
Sponsored LinksLatest Posts
|
more posts...