Hi, I have a Sony DCR-TRV9 and all my settings keep getting reset. I located the internal battery and tested it with a multimeter to verify that it is indeed dead. The problem is the battery has no ma...
... 4-cyl auto. Trying to teach my roomie how to do car maintenance, I forgot to mention "disconnect the battery". He managed to bridge from the #2 spark plug to the top wire connection on the ...
... to convert some tapes to DVD but at the moment the unit only powers up for a few seconds, indicates a low battery and then shuts down. I would expect this if I was using a battery, however I am curre...
...tteries so i could place them on a trickle charger. When I hooked them back up I get no lights when on the battery power. When connected to house power all lights work. I replaced the batteries and tr...
...omer I must have mixed it up with a different type of Sony camcorder. Could you try this:
1. pull off the battery completely.
2. leave the door of the eject area open.
3. reconnect the battery with...
...I could by wrapping a copper wire around the tool and hooking the other end of the copper wire to a 9 volt battery. And if this is possible, which connector of the battery, positive or negative?
t...
Hehe...you're both right. Airbags are indeed powered off the battery. One of the functions of the airbag module however, is to provide keep-alive power for a few minutes in the event that the bat...
Has the battery gone dead, or the battery cable been off?
The Cat Con Eff needs time to get ready, this is also a problem on vehicles that arnt driven much.
Just need to be driven more.
If its ...
I have a 97 Astro van the battery light was coming on once and awhile but if I rev the engine it would go off and the voltage go back to normal.Now the light is off when I start the van in the morning...
...stop or slowing down. The engine obviously dies too. The power will usually come back when I fidget w/ the battery terminals and I can start the car again. Sometimes I need only touch a terminal w/ my...
will it work without the battery. maybe the battery is bad.
Remove the battery. then take the covers off, and use a blow dryer (on no heat) to blow out everywhere. Get the battery out first though, even a little condensation internally can kill specific comp...
i disconnected the negative battery cable and then the ignition worked fine, and shifted fine when i turn the key on the on position ( the battery cable still disconnect thought) but when i hooked the...
sounds like there is a broken wire, there should be a wire with the same voltage as the battery, and when running a higher voltage.
See if u can find the wire coming from the battery, it should be ...
Remove negative battery cable. Remove the wires from the terminals on the starter (should be a small one and the other end of the battery cable).
Support the weight of the starter ( about the weig...
... to convert some tapes to DVD but at the moment the unit only powers up for a few seconds, indicates a low battery and then shuts down. The battery has a full charge and the power adaptor is connected...
...'s easiest to just take it to one of the chain auto parts stores. Generally free.
On car....check battery voltage across the battery terminals with engine not running.
Start engine, and ev...
....
My son and I are working on a project for his class. What I would like to do is to somehow hook up a battery (maybe 9volt) to a digital timer so that the power from the battery will turn a small...
I have a sony dcr-trv520 and everytime I power it up I get a flashing battery signal with a slash thru it and the power goes off. This happens with the batteries fully charged and with different batte...
I mean battery to "reset the computer." Same on my 87 300ZX, after addinmg somethin like a high flow air sheepishly filter or a bit less restrictive exhaust. Looking at it you reconect the ...
...leads hit ground after a couple fuses and doohickies. wow that wasnt that fun so i smashed,ok cracked, the battery appart and two are tied together. so my assumption is the third lead on the battery t...
Disconnect the battery positive cable and then turn your ignition (hold) to the on position for at least 1 minute and release. Connect the battery cable and then turn the key to the off position.
disconnect negtive battery post clamp remove for ten-sec. reconnect battery.code settings will reset after 50 miles.so if engine acts funny, no alarm setting have to have a chance to reset.
own thr...
...e saying that not even your dashboard is lighting up, then you must have a main fuse blown. Any amount of battery will light dashboard. You are not getting power to it.
How did you check the item...
Remove negative battery cable. Remove the wires from the terminals on the starter (should be a small one and the other end of the battery cable).
Support the weight of the starter ( about the weigh...
Remove negative battery cable. Remove the wires from the terminals on the starter (should be a small one and the other end of the battery cable).
Support the weight of the starter ( about the weigh...
...ausing your car to just shut down. the starter is used to start the car thats it. the alternator keeps the battery charged. if the car is loosing power like the lights etc go dim and the car stalls an...
... a multimeter and check the ground by using the lowest ohms setting place one of the leads on the Negative battery terminal/cable and the other lead on the Negative battery post. The multimeter should...
...urning over to try and start when i switched the ignition from on to off it kept going until it killed the battery even though ignition was off!!!
I changed battery and it did the same thing except ...
Need schematic for a 9v (7.2) However battery chagrer. Others would usually agree what's the difference betwween NI-CD
The Content on this site is provided for general information purposes only. Your use of the Content, or any part thereof, is made solely at Your own risk and responsibility. By entering this site you declare you read and agreed to its
Terms, Rules & Privacy.
Copyright © 2006 - 2010 DIY Forums