Does any one know of any website that specializes in custom reupholstered boat seats? I have back-to-back boat seats
For example please could any one avdise me: I have got a 15ft fibre glass boat with woden floor the floor has some fibre glass resin at the sides presumably to fix it in place.
My probnlem is the f...
As usual you might want to build a real boat this winter. consciously viking boat plans http://www.lp.se/gerrie-warner/boat.htm
need to create more room in my boat and add a center console. the boat is an all aluminum v hull. decks front and rear and need ideas.
...n & go pike apparently fishing in Scotland 2 or three times a year. Although I`ve no experience of boat building I`ll like to look in to the possibvilities of intrinsically building a small wood...
I`m looking for a plan for a trailerable fish/sport boat in the 16-20 ft. range built using stitch and glue (or is that tack and tape?) I`d like to use the boat for fishing, but would also want to ...
I want to build a boat out of two liter soda botles.
Why? Why not? I can make the time and the space to do it and it's irritably somehting I've wanted to do for a while.
Similarly i'...
Though i'm attemptin to fix/clean-up a 24ft pontoon boat. I'd like to start out by cleaninbg up
Ummm...ok. What's your question ?
Details on the boat will help as well, as will telling us what you do the most of with the boat.
Try this site,www.Boat Design.net
Here are some complete and simple plans for a smaller but very genuine viking boat: http://goto.glocalnet.net/startsida/vikingboats/
canoe.htm
...ing the same link in old threads all over the forum im going to sticky this. if your looking for viking boat planes go here http://goto.glocalnet.net/startsida/vikingboats/
canoe.htm ...
Im putting a new floor in my boat. So I ordered 4 sheets of 4x8 1/2 in. marine plywood AB. When I picked up the plywood it doesn't look like its green treated. Is that normal. Thanks
Any good books on steel boat repair? I see a lot on building, but not much on how to referb an old steel boat. Lots of sites say "easy" but i'm looking for a step by step book.
Thank...
Has any one installed a 230 HP plus in a kit pontoon boat
how to drain gas from boat
How big of a boat are you considering?
//Gerrie
Do you store your boat over winter with a full tank of gas? I was wondering what the right thing to do was, especially taking into consideration that sometime in Ferbuary I will be trailing her down t...
...are easy to lay out and cut, epoxy is extremely tolerant of gaps and imperfections in the cuts, and the boat becomes '3D' very early in the build.
That last one is what discourages many peo...
this guy told me that a boat can sink on its trailer and its covered by insurance. is this true?
how can I handpaint a small fiberglass boat
i have a 16ft fisher all aluminum bass boat that i would like to convert to a center console. the front deck has 1 livewell and 1 storage compartment arranged one behind the other. the total length o...
We have a new moderator for the Boat Repair topic:
http://www.diyforums.net/members/crankybadger/
Welcome Crankybadger
I have an outboard motor for my boat that runs fine on land, but wont run at all in the water. any Ideas as to why?
I have a bad PRV in my boat's electric hot water tank. Would this have essentially the same PRV as on a HWT? Or could they have different set points?
...john
I recently purchased a 1980 16' Lund fishing boat and the decking is soft in spots and I would like to replace all the decking and modify the floor plan. I'm a little worried about cutting i...
when i turn the key the motor starts than dies immediately...there is spark and i see the fuel dripping in the carb.......i have a 3.0 mercruiser , any suggestions would help
The Content on this site is provided for general information purposes only. Your use of the Content, or any part thereof, is made solely at Your own risk and responsibility. By entering this site you declare you read and agreed to its
Terms, Rules & Privacy.
Copyright © 2006 - 2010 DIY Forums