Chain saw gas lines replacement

I am replacing fuel lines on a Poulan 2150. The instructions I got with the new primer and fuel filter shows only two lines. One from tank to primer,one from primer to carb. But there are two intakes from carbs. Any suggestions or diagrams.

Post edited by: flgator, at: 2008/08/17 20:36

flgator,

Welcome to the Forum !

As I recall, there are several models !

Is it possible you chose the wrong Kit number (Serries 1 thru 7)?
Best I can offer with limited info,

Have a good Day !
S.W.

Post edited by: SWHouston, at: 2008/08/17 20:44

Hi flgator welcome to the forum
I hope you can get back with a confirmation of what S.W. asked soon

I am working on the same problem. The 2150 has a fuel line running from the tank to the bulb and from the bulb to the carb. The carb also has another nib for a line but I dont know where that line goes. I see it in no parts list mockups. My orig. line was brittle junk and fell apart. Replacing plastic tubing is easy if you know where the ends go. That fuel filter going on the nib inside the tank looks fairly stupid as well.

Any help out there for this mystery line into the carb?

Ok...large fuel line coming from tank into primer bulb. Large line running from primer bulb into lower carb nib. Smaller fuel line running from upper carb nib into small hole into fuel tank connecting inside with fuel filter.

SW, I did not buy a kit. I bought a new bulb and fuel lines. I can not find what series the saw is. Only one hole is in gas tank and two connections on the carb.

O.K.-First of all connect a line to the nib inside the tank to top fuel nib on priming bulb then connect bottom fuel line to bottom nib on priming bulb to bottom nip on carb then connect fuel line to fuel pickup to top carb nib