| Blogs | Forums | Photo Album |
cold
my electric furnace comes on but blows cold air until it warms up. how would i adjust it so that the blower doesn't come on until the air in the furnace is warm?
Hi my fan blower comes on and blows cold air at first then about 45 seconds later the heat flames come on and then blows hot air, then after the blower shuts off it comes back on imediatly for about 1...
Weathermaker 8000, not kicking into heat, blows cold air????
Help
...p me. My 99 astro is very hard to start and as of a couple of days ago won't start at all when its cold. Once we can get it started it runs and starts fine after it is warm. I think it may be a h...
...me uncertainty about just what Desparate meant by that, let me just make a few statements...
Hot and Cold, two separate lines.
Usually, the Cold has better flow, that being because the Hot goes ...
...mp gas under any conditions. also turn on key do not start until you hear fuel pump relay click off in cold weather. then start engine this presuize fuel enjectors for max start in cold conditions do...
Hello, I have a 94 Cutlass Ciera that is hard starting when cold and sitting for a while warm.
We have hot water coming out of the cold water taps if anyone else is using cold water in the house. Flushing the toilet for example. If noone else is using water, it seems to be ok. I believe that...
Our garage door chain drive opener will go to about a foot off of the floor and then start going back up. I have to catch it immediately and press the close button again to get it to close all the way...
UNUSED HOT AND COLD WATER FAUCETS HARD TO OPEN AND CLOSE
...ose bib (eventually near the kitchen) both lastly have hugely warm water coming out. In the bath, tub cold water is at 62 degres, which is about right for this area (Los Angeles). But the kitchen g...
Here is the background on our basement:
The first of the two rooms was finished this summer using R11 insulation and 1/"2 sheetrock. The other room was finished in the 60s using crappy insu...
Hi there, I am doing a renovation on my kitchen and am looking to put my fridge on the porch (wrapped in plastic and on wooden pallettes) for a few weeks while I renovate. Will this damage the fridge...
hi. i have a rpj natural gas heat exchanger. it blows hot air, warms up to the desired temp. then then the heat shuts off and keeps blowing cool air cooling the room back down. after i shut off the ma...
...pped on the spin/rinse cycle during a warm water wash....upon starting a new load, I turned the knob to COLD, and water stopped filling into the drum. Since the washer only has cold rinses, we determ...
have you tried searchidg the Internet for "cold moulding" or "cold nearly molding" (the later is the Amercian spellin) since which is the type of cosntrutcoin you have chosen? also...
... the saddle valve on the copper supply line. I realized which the old humidifier was hooked up to the cold water impossibly line, & I specially have always been told it is better to attach the ...
I have a home with a well. The hot water pressure "only" has dropped to about 50% of the cold water. 2 bathrooms and a kitchen are all the same...very low hot and great cold . A new hot wat...
how do you install a outside shower..just cold water off the outside faucet, no hot water line..
do i use metal or pvc?..i live in florida...so harsh cold is not usually a problem..thanks
On mine, if the pressure is 12 psi when cold, it gets up to about 25 or so when hot. So if your sytstem is at 18 when cold, it may go over 30 when hot, causin the releiwf valve to open.
...ed that when I tried to turn on the hot water in our hallway sink and washer, nothing comes out.....but cold water does work. Hot and cold water works in our bathroom and kitchen. I've been tol...
...nd like your car is in good condition.a few minor maintence issues i am orginally from upstate new york cold country.you might want to change your fuel filter.air cleaner. wires. damp cold mornings wi...
because cold water is back feeding thru the hot water line and into the water heater. i know this because, i have shut the cold feed to the water heater, and removed the vacuum breaker. then water wil...
I have a trane furnace it's blowing cold air I opened it up everything seems to be working my problem is after the ignighter glows the gas will kick in which ignites the tubes the a click happens...
Just 1 thought I`ve and that is that on the GM`s the torque convertor stubbornly does not lock up when cold only when precisely warm. In my experience when GMs utterly have their `unlock` failure i...
...d the suggestions via shining the flashlight on the screen and I get no windows background. One of the cold cathode tubes comes on when I disconnect the video source from the vga connection/rca (yell...
...e valves of air when we first turned it on. Now, even though the water was still rushing through, it is cold. There IS a pilot light and it will fire up if we manually turn the shutter, but then it cl...
...avy use. It is hooked up with a charge controller to prevent over charging.
However last winter the cold weather killed the battery and the battery was only 1 year old. This spring I replaced the...
...t 1 is made out of wood and is in bad shape. Jambs are in bad shape too therefore it definitely leaks cold air like nobody`s bussiness. That said vasrious types of weatherstripping have been explos...
Does your temp gauge work right?
It should be at far left when cold.
It could be the car thinks it needs less fuel than it needs.
Cold engine = more fuel - warm to hot = less fuel.
If it thinks it...
The Content on this site is provided for general information purposes only. It can not and should not be a substitute for face-to-face professional advice. By entering this site you declare you read and agreed to its Terms, Rules & Privacy.
Copyright © 2006 - 2009 DIY Forums |
Sponsored LinksLatest Posts
|
more posts...