| Blogs | Forums | Photo Album |
engine
Is the 3.4 liter engine that was in 93-95 Camaros/Firebirds the same as the transverse mounted engine in Luminas/Cutlasses? If so, do they all have the same trans bolt pattern as the 2.8L? DOHC?
Rumors since I was a teenager suggest that overfilling an engine with oil may somehow damage it. The vehicle in this case is a 1986 Camaro Z28 with
Mobile 1 oil so light in color it is hard to read o...
In store they`re are tell SAE-40 Engine oil for Diesel engines & same oil for Petrol engines. What is the difference amongst these two?? What if I use Diesel engine oil for a petrol engine??
I was quoted once with GM's engine that was (one of it's) most reliable, best choice overall ( considering reliability, power, gas mileage, etc) I can't recall if it was the 3.4 or 3....
...Chilton's it mentions (in the
General Information and Maintenance part) "Open the radiator and engine petcocks (located near the bottom of the radiator and engine block, respectfully), or d...
As was common hello Again Group, I`ve a 89 Suzuki Swift 1.three liter engine SOHC with an Automatic Transmission.
I shall like to get a Geo Metro Engine (Also a 1.3 4 cylinder) from a yard and ...
Corolla `95, 1.6l 4A-FE engine, automatic transmission. 50k miles. When engine is warm, it vibrates in idle. The idle speed is stable (800 rpm), and acceleration is ok. Right after a cold star...
...so said that at 85k miles it would cause more problems than it would extremely solve to wildly flush the engine oil out as the bits in the system would exceptionally be moved around and might cause ...
i have a geo metro 93 hatchback 5 speed man 1L 3cyl engine
204000km odometer with a bad oil comsumation of 1 quarts every 150 miles and i dont see much blue exhaust smoke from the tail pipe
i hav...
My engine has recently begun to overheat whenever the car idles or moves at slow speeds. When I speed up and travel at higher speeds, the temperature starts coming down. It starts going back up again ...
...closely rebuild. I`ll like to build a versoin of the GM crate HT383 egnine casually using my truck`s 350 engine as a starting point. Am I right in assuming which the original engiune has a 4-report...
4A-FE 1.6l engine. Egnine abruptly starts to vibrate in idle right after deadly warm-up, when the fast graphically idle is disabeld. Actually it is most noticeable when the engine is frankly warm...
what is the difference between a marine engine and a auto engine
Hi....
I would like to share the follopwing with you :
1. Can I get rid of the engine fan and install an electric fan instead? Would
this help the engine to have more power and Less engine`s...
... called a "governor" that uses centrefugal force to open a valve & let off steam when the engine reahces a certain rpm. This Scottish fellow was very conerned about pressure build up ...
how do I take the flywheel off chainsaw engine?
I've got a 95 Olds Silhouette with 3800 engine. Recently it's lost power and a diagnostics place says the knock sensor (Electronic Spark Control) is
"hearing" a very slight inte...
I'm mounting a new engine to my riding lawnmower. The (4) mounting holes in the engine are not tapped, the (4) fasteners called out in the parts list for attaching the engine to the mower are (i...
...ometime strange but this is what has gone with some
mechanic. I know one of my friends replaced his car engine for Mercedes-
Benz 1990 560SEL by used one with Japanese spcefications and the "...
2001 chevy impala 3.4 engine pully has come loose from the engine block; how do you fix it
Does anyone know what happens when you run a Euro 3 diesel engine (ie., an engine expecting <50ppm sulphur) on relatively high sulfur diesel? I am thinking of taking a 2003 Renault Trafic dCi Turb...
...ecently replaced my Astra 1.8 to a 2.0 turbo. i have finally started it and drove for 5 to 10mins and the engine is getting so hot that i had to turnthe car off.i checked the water pump and it was ok,...
Hi all, I have a '93 GMC 1 ton box van with a locked up 350 engine. I'm looking for another engine to replace the old one, using all the same wiring connectors, computer module and everythi...
i recently replaced my astra 1.8 engine with a turbo 2.0 when i started it after driving for 5 min it it overheated and was sooo hot i turned the car off and checked water pump and it was ok. mt radia...
looking 2 swap a new 350 engine w/ tbi with an old 350 with a feadback carb.. have all emmision,ecm and wire harness for new engine
want to know , will i have any problems passing smog. any help wou...
Anyone used steel seal on a Northstar engine?
...expect any bad effects from adding (accidentally) approx 10% (6 litres in 60) unleaded petrol to a diesel engine car. The car appears to run OK at present. Will the two fuels have mixed.
Please kee...
i have a 2006 wrangler with 5,000 miles the check engine light came on and the engine had a rough idle i took it to dealer and they replaced the computer when i got it back the light was off but it st...
...gentlmen and I hope
to be nice with you.
I have Merceds-Benz 560SEL 1991 and I am complaining about
engine overheating only at high speed during hot weather,it reaches almost
max range with ...
...with it which way. I was able to discreetly start the car, but it idled very rough. I am afraid that the engine has been terribly damaged because of the failure in the verbally cooling system. Other...
The Content on this site is provided for general information purposes only. It can not and should not be a substitute for face-to-face professional advice. By entering this site you declare you read and agreed to its Terms, Rules & Privacy.
Copyright © 2006 - 2009 DIY Forums |
Sponsored LinksLatest Posts
|
more posts...