engine
Can a install 3.1L heads on a 3.4L Camaro engine?
will it crank. do you have spark. is the engine getting fuel.
...eed to check the voltage as the ignition goes on, there is only power to the pump for a few second if the engine does not start.
You can try bypassing the relay and see if that works....
...to do some jockeying around with the pulleys.hope the valves did not hammer pistion s depending which 262 engine you got.ford owns mazada last years of mfg. the escort models were mazada.if you confus...
Ok I have a 1996 Chev K pickup with a vortec 5.7L engine that cranks and wont start. I borrowed a GMC scan tool and found that I have no communication to the Engine control computer but communications...
might have got some water in the engine.
Did you put new oil in??
How does one go about diagnosing an engine if it has a blown head gasket? About how much would it
cost at a mechanic's?
the shaking sounds like your engine mounts are either worn out or improperly installed
I read something about it being on the lefthand side of the engine compartment. Does that mean anything to you?
Hi key, welcome to the forum
Perhaps you have to clean the engine...
I Have a 3.4l DHOC Engine and it will not start I do not have a spark what gives
Hi Armandoh73, welcome to the forum
This must be a problem with your engine. You can have this you better checked by a professional.
the kbb value is around 4500-5000$...Overall condition is good. It has new paint. Engine looks great and when it runs it's like new.
I went already to 3 mechanics...so it is hard to be sure I gu...
...lysimms welcome to the forum
Have you checked if the antifreeze is circulating properly through the engine?...
what is the proper valve adjustments for a 350 chevy with the engine running?
can someone tell me when the timing belt breaks on this engine how do you line up the cams and the crank with no marks thanks
check the ground( negative) cable where it connects to the engine block
We need more info, such as year - make - engine , and etc.
Most engines are different
There should be one in the exhaust manifold not to far from the engine, and another behind the catalyst converter.
I'm considering replacing my old gas sailboat engine with an electric motor, and looking for some past experiences before starting in.
... when at low gears. 1st and 2nd usually. There would be a delay when switching from 1st to 2nd gear. The engine would rev up and take a long time to fully engage the 2nd gear. Sometimes it would jump...
MY CAR WON'T SHIFT INTO ANY GEAR AND IT SMELLS LIKE BURNING RUBBER UNDER THE ENGINE
...s not a transmission related issue. He drove it around for a while and said it sounded more like that the engine was mis-firing. He also noted that the RPM's didn't have any improper fluxua...
...runk light all this can drain battery. turn on head lights, heater motor on high, wipers on low warm up engine to a idle. remove neg cable, at this point alt is at max output.
2 or 3 sec only. ...
I have a 1988 Chevrolet celebrrity and there is no spark in the engine..what could be wrong?
...ld be looking at starter problems.
And when you said failed to start, you should also include if the the engine rotates properly, if it sounds different, and etc....
it would be the ignition coil. im betting its a tecumseh engine.
Did you check the CV joints.
Does the speedo do anything if the car is in gear and engine running?
how do i check and adjust timing on a 99 ram 1500 with engine code of y?
if the starter just clicks, try turning the engine by hand, if it turns, try jumping it again, and let it boost for about 5 min before trying to start it.
The Content on this site is provided for general information purposes only. Your use of the Content, or any part thereof, is made solely at Your own risk and responsibility. By entering this site you declare you read and agreed to its Terms, Rules & Privacy.
Copyright © 2006 - 2010 DIY Forums |
TIP: Write your question in details [ why? ]
Sponsored LinksLatest Posts
|
more posts...