your new engine is bigger and the old radiator is designed for 1.8 non turbo engine...
or it might be the water valve that is blocking the water flow.. located near the exit of the engine hose retu...
I'm mounting a new engine to my riding lawnmower. The (4) mounting holes in the engine are not tapped, the (4) fasteners called out in the parts list for attaching the engine to the mower are (i...
i have a 1999 ford taurus station wagon with v6 dohc engine 60,00 miles. when i went to start it this morning the engine would no fire up, the starter just kept spinning. i gave up after a few tries &...
i finally blew the motor in my truck which has a manual transmission.I bought a used engine from a 1987 nissan pathfinder which had an automatic transmission.my old engine still had the pilot bushing...
engine runs rough when cold but good when warm.
get a po118 code
...gentlmen and I hope
to be nice with you.
I have Merceds-Benz 560SEL 1991 and I am complaining about
engine overheating only at high speed during hot weather,it reaches almost
max range with ...
what is the difference between a marine engine and a auto engine
i have a 2006 wrangler with 5,000 miles the check engine light came on and the engine had a rough idle i took it to dealer and they replaced the computer when i got it back the light was off but it st...
toro s200 removed covers and engine and all components seem to be covered in an oily residue and im wondering what is causing this or is it normal for them. Its a model 31820 s-200
Sometimes,once every 10 times or so,upon start-up the engine races fast and slow like someone is operating the gas pedel up and down. The tach races between 500 and 4000. Shut the engine off, restart ...
how to adjust governor on 5hp tecumseh engine
...ek.and see whats disappearing.check your oil for white foam.check you coolant for oil.have some start the engine stand by tail pipe and see if their and smoke ailke:
1:white steam or vapor is coola...
murray snowblower starts and then engine dies out
2001 chevy impala 3.4 engine pully has come loose from the engine block; how do you fix it
oxygen sensor is responsable for fuel flow to the injectors the engine could be flooding out disconnect negitive cable only reset code back to computor run value , and see if engine will runs if it do...
i have a 3.4 liter engine that runs great looking for a list of cars that motor will fit in
what's a list of all possible causes on a 3.4l sfi engine (camaro) that causes it not to fire;we've already done one crank sensor,coil pack,ign module etc.?
what is the best engine stop leak for a newer car.
can i put a dohc on a sohc vauxhall astra engine
i was wounding what cars the 93 chevy lumina 3.1 engine will fit in. if someone could help me i would really appreciate it.
toro engine appears to have locked up, rope start will not pull out at all, any ideas
I had a re-built 3.4 litre engine replaced approx. 22,000 km's ago. I took it for an oil change today and my mechanic says there's a engine oil leak somewhere. He tried to find the spot but ...
What is a "MIL / Check Engine Light" failure. How can this be corrected
what is the principles of an 2 stroke engine
what is the best engine stop leak for a newer car.
Hi,
Im removing a 86 manual celica engine.
Im planning to remove the engine along with the transmission. In order to do that ive detached most of the stuff in there. However, i cant seem to figu...
Hi all:
Yard Machine Snowblower
8 hp Temumseh engine.
Hard started but finally got it going only to find the auger isn't turning.
Also notice gas leaking when primer is pressed.
Any id...
...i find a way to close the shaft from with in the pan will it stop the oil from getting to the rest of the engine please help oil is expensive and it leaks badly thanks...
...appens all the time. What kind of tractor is it?...doesn't matter, look up the model number of the engine (it's on the engine)...
then:
http://www.briggsandstratton.com/maint_repair/
...
The Content on this site is provided for general information purposes only. Your use of the Content, or any part thereof, is made solely at Your own risk and responsibility. By entering this site you declare you read and agreed to its
Terms, Rules & Privacy.
Copyright © 2006 - 2010 DIY Forums