engine
In a sense i`ve a leaky engine & cannot find the leak. I was softly thikning of using Gold Eagle`s NO LEAK. Does it realy fatally work? Does it adversely effect the engine or abnormally cool...
I have a 1988 Chevrolet Celebrity with a V-6 2.8L engine and there is no spark in the engine. I was told that it could be the crankshaft postion sensor but not sure b.c i cant find it...can someone he...
I just rebuilt carburator and engine works fine but when I blow snow the engine wants to cut out. Its probably the govenor. What can I do?
Depending on the engine in question.
And some heads need different computers and wiring harness.
I would suggest find a forum dedicated to that car or engine and see if anybody has done and see what...
...time to check it out - and I lack experience when it comes to vehicles.
They also said that I have two engine mounts broken and my transmission mount is about to break. So that'll be $600 mor...
While blowing snow the engine reved up very high, then instantly slowed to a very low idle. The engine will start, but has no power. Any suggestions as to what the problem could be is appreciated.
overflow tank. As the engine cools the coolant contracts creating a vacuum and pulling the fluid back out of the overflow. There is no way for the engine to pull coolant from the overflow with the e...
if you have a compression tester remove one of the sparkplugs and crank the engine and see what it reads. this will tell you if the engine is turning with the starter. it sounds like a electrical prob...
... rough, like its running on three cylinders. It usually smooths out after a minute or so. If I stop the engine and then start it soon after while it's still hot then it invariably happens. som...
...er pump, temp control sensors. Now the mechanic is telling us that we have a 'milkshake' in the engine. That anitfreeze is getting into the engine block. What should I so with this car?...
First need Year - make - engine type.
Most newer engined use pilot tools to set the timing, 8mm holes that line up with a hole on the engine.
remove the sparkplug. put a teaspoon of gas into tht sparkplug hole and replace the plug. crank the engine. will it run for a second or so. if so then the carb needs cleaning or a rebuild. if it still...
...l injected). After driving the open road for a good amount of time, all of a sudden I loose all power. Engine does not stall but it runs very rough w/ no power at all!
After sitting on side of r...
...elt on escort should have been changed at least twice.with in 85 thousand miles.this is a mazada 262 this engine is hard on timming belts.the water pump and belt should be changed at the same time.if ...
...t capacity for the car.
Question is this: Is the full coolant capacity stored in the radiator when the engine is cold?
Once I install the new radiator and fill with coolant am I done?
Or, do ...
1998 Honda Accord EX. Problem: Engine light on. Took the car to check the code and it came back with too many codes to count. ie P0300,P0301,P0302,P0303,P0505,and P0420. The guy was nice to tell me I ...
The problem with this kind of "I use it and my engine runs great" report is that...well, forgive me stepping on your feelings, Rob, but they're meaningless. If you said "We have tw...
...light on, for instance, I can jump the battery with no problem but as soon as the cables are removed, the engine stops. I can take the battery and get it charged and then everything is fine.
One t...
thats the nower model. not the engine. I'll see if I can find the engine model under the grime.
...n:
Most importantly, the last few pages in 692509.pdf contain cross-reference
between Sears Craftsman engine part number and Tecumseh engine model number!...
...s but will not shift out of first but will go into reverse, a fair amount oil inside of hood and all over engine like it was blown there and had approxiamately a 2 foot puddle of oil on the ground und...
...n:
Most importantly, the last few pages in 692509.pdf contain cross-reference
between Sears Craftsman engine part number and Tecumseh engine model number!...
Well it just that the only cars are available here are for the low sulphur environment. To get the engine changed would be complicated (and costly?) And to buy in the country I'm going to would b...
I have a 78 350 Chevy truck engine installed in a street rod. The engine has about 65 lbs of oil pressure at startup and settles down to about 35-40 around town. I recently did a compression check and...
what engine sensor could be in several places.
so engine ????
... than starting the car a few extra times.
Next time, keep a close eye on the oil level- obviously this engine burns a little oil. No big deal, just keep it full from now on.
Running with the lev...
first the 2.0 Zetec engine has 120,000 miles on it.
the cooling fan began staying on after the car was turned off, and engine was cooled down.
We would pull the 40 amp fuse to shut off the fan (...
sorry -- I have a 1996 chevy astro 6cyl 4.6 gfi I have to squirt gas into the manifold to start the engine. I have replaced the fuel pump (2nd time in 1 year) and the fuel filter. It started slowly ...
& other factors. Subsequently as a very very approximate immensely rule for std road engines with std OE manufatcurers road cams you shuold expect the cranking pressure to be among 18 & 20 t...
Hi
Will talk to mechanic tomorrow to see if a rebuilt engine is available. Makes sense to go with a rebuilt engine swap as hours are probably the same expecially if planning the head is required. ...
The Content on this site is provided for general information purposes only. Your use of the Content, or any part thereof, is made solely at Your own risk and responsibility. By entering this site you declare you read and agreed to its Terms, Rules & Privacy.
Copyright © 2006 - 2010 DIY Forums |
TIP: Write your question in details [ why? ]
Sponsored LinksLatest Posts
|
more posts...