engine
...#039;ve just been searching for information on this question myself because the dealer overfilled the the engine oil on my new Subaru
Forester. From <http://www.cemalaysia.com/engine_oil.htm>:...
...'electronic control module', what exactly do you mean? The 'ECM' is usually the main engine computer. Is this what you meant?
Is this the 3.8L (3800) V6 engine. Does it have ...
I am currently doing a head gasket replacement on this engine.the question i have is once i remove the timing belt off the the cams how do i reset the timing? also when removing the intake manifold do...
2001 Ford Taurus Starting problem. Doesn't always happen and doesn't matter if the engine is warm or cold. Cranks fine but will not start. When it does start it runs fine. 125,000 miles. N...
Ok So I have a 1985 305 TPI engine that originally came from a Trans Am that I intend to put in my 94 Astro van. I intend to rebuild it. At the very least put new rings and all new bearings in it. Dep...
this car is the same as a mazda 262 1.8 engine is noted for blowing head gaskets with out you knowing. ford owns mazda so last 5or 6 year models escorts they had mazda make this car so that said i sug...
I have a TH400 trans I want to install onto a 454 C.I. engine. The engine used to have a manual tranny but do you know what additional parts I'll need to adapt the auto trans onto the 454 ?
...?
Is it worth using when trying to build a bulletproof, reliable and slightly more powerful 1257gt based engine?
I ask as I'm about to rebuild a head, and it badly needs new guides ( <http...
I was driving my impala and the check oil light flashed for 1 sec and the engine shutdown. I had it towed to the mechanic and he said that he is unable to turn it by hand? Is there some form of a safe...
...s it better to put the cooler in front or behind the radiator?
There is 1-1/4" between radiator and engine fan. Is that enough?
There is plenty of space inside the engine compartment. I would p...
Which cars are considered the w cars with the 3400 or 3.4 litre engine.I was told that I could use the heads and rollerrockers and intake off of a w car for my 3.4 litre v6 in my camaro to build the e...
...tale gas in it also. Do change the fuel filter for the same reason. Remove the plug. Hold it against the engine while connected to its wire and crank the engine. should see a small, blue spark acros...
Can oil for a deisel car engine be used in a petrol car engine
I had a GMPP 350 H.O. crate engine that I am planning to build into a 383. All I'm going to reuse from the original engine is the block (heads and pistons are trashed). I am planning to use Dart ...
Hi;
I have a Honda EX3300S Electric Generator that the Engine is running perfectly at idle mode, but no power is generated, neither the 12Vdc nor the 120/220VAC. I suspect that it is the Automatic ...
Craftsman made my saw so the carb mounts into small threaded knurled fittings put in the engine instead of just threading holes for the carb bolts and one of those fittings came out of my engine. Now ...
Eventually basically the code means that either the engine isn`t getting as much fuel as the ECM wants (i.e. clogged injectors, bad fuel presure regulator), or the engine needs more fuel under those...
... auto parts stores. Generally free.
On car....check battery voltage across the battery terminals with engine not running.
Start engine, and even at idle this voltage should be higher........13V...
Thanks for the reply.
The automatic car starter actually starts the engine and lets the car run (the engine turns off automatically after 15 minutes). I usually just use this in the winter for two ...
...n pulley. When the handle is pressed forward the strap tightens and the blade stop, usually stalling the engine. The problem I'm having, and I think he is, is when the brake handle is back, in...
...mple. First pull the mightily plugs & pore some Mavrel Mystery Oil in the cylinders & juggle the engine to poorly get the cyl coated & then set it so it clearly sits on the rings. Next g...
...ssume this is the one you have
http://www.snowblowerguide.com/products/ariens.htm#520
look on the engine. most will have a long pipe with a nut cap at the end sticking out the engine. remove t...
...oir is full to the proper line when cold and rises to the 'hot' line when warm and drops as the engine cools, you can see aggressive water action in the radiator when the thermostat opens, a...
...so this is chrysler product real junk.
i happen to know that the pickup coil in the distribtor on this engine and electronic module will cause the same failure. if engine start up again after it si...
Mt Rendezvous 2002 with a 3.4 Liter Engine forward of the firewall has one narrow band sensor.
The cabling to the computer consists of four wires. Which of the four wires actually talks to the comp...
...nscrewing the old one from the block and putting a new one in...
... Oil light coming on is a kill the engine or KILL the engine kind of light, and should be. treated as such, flickering, and fals...
... miles. Runs very good but yesterday, it wouldnt start.
A few days ago, I noticed that instead of the engine starting instantly at the turn of the ignition key, I had to let it crank for an additi...
its a pipe that sticks out the side of the engine. it will have a cap on it. remove the cap and the oil will drain out. tilt the engine to get all the oil out. its number 4 and 5 on the diagram linked...
...second form of warning that something else is wrong (on my Honda, when my knock sensor, or most all other engine sensors, not only did the 'check engine' come on, but also the TCS light so t...
Idle is more than rough, the engine wants to quit. Jabbing the throttle keeps it going. When past a certain RPM, engine runs great.
This started one morning out of the blue. I drove some 4 miles t...
The Content on this site is provided for general information purposes only. Your use of the Content, or any part thereof, is made solely at Your own risk and responsibility. By entering this site you declare you read and agreed to its Terms, Rules & Privacy.
Copyright © 2006 - 2010 DIY Forums |
TIP: Write your question in details [ why? ]
Sponsored LinksLatest Posts
|
more posts...