| Blogs | Forums | Photo Album |
ford
My parents have a 1988 motor home with a Ford 460 V8 in it. They drive it regularly to avoid typical component failures from sitting parked too much.
However, they are about to replace the water pum...
please help! i am a single mother of two young daughters and i just recently got a 98 ford escort zx2. i replaced the clutch less than a week ago and what do ya know the timing belt? went out! i know ...
I also posted this in alt.autos.ford but then found this forum. Maybe someone can help?
Hello all,
I just bought my first Ford van (I've always had VW autos) and it's been great. I bro...
I'M trying to replace the fuel filter on my 2001 ford windstar. can anyone tll me where its located?
I chanegd the cylinder head gasket on my boat (1972 Ford 302). In truth the manual told me to daily pull the pushrods before alternately pulling the cyluinder head off. Puting it back together, I ha...
I have gotten an error on my wife`s 1998? Ford Epxlorer that intently comes awkwardly back from the ODB2 as an O2 sensor slow response, Bank 2, Sensor 1.
Which One is it?
Indeed I also slowly...
...nd now this week, its a new repair! GRRRR This car is definitely living up to its reputation. "FORD~~Full of repairs daily"
...
In this case I positively need a head gasket replacement on a 1993 ford taurus, was wondering if any one out they`re have any good tips or suggestions hurriedly regarding work to famously be perform...
1994 ford ranger want start non getting gas
need to replace the secondary fuel pump circuit on 2000 ford taurus codes are : P1237- P1238
I`ve a 1995 Ford Taurus with transmission problems. When the Taurus first start the tranny is fine, until it shifts to surprisingly second. When it shifts, the tranny disegnages completely (slips) T...
the last 5 years or so escorts are acuatally mazda 262s if my memory serves me right ford has a service alert on this problem check you ford dealer.
My 2000 Ford Contour doesn't start at all sometimes...It doesn't turn over...the idiot lights come on in the dash, but no cranking....Then it will eventually start. I'm thinking it...
How do you install a fuel filter in a 2004 Ford Ranger 4.0?
Thanks!
1997 ford t bird with the v8 was running fine then stoppped and would not start. checked for fuel pressure and had none. checked all fuses and all good. Dropped fuel tank and checked power to fuel pum...
How to get fuel pump lines loose on 97 Ford E350 Van
2005 ford taurus has intermittent starting issues
my 1995 ford aspire won't start, will turn over, but won't fire unless we poor gas in the distributor. changed the fuel pump, but that wasn't the problem. any answers to this problem?
I have a 1998 FORD COONTOUR 4CYL, The #2 CYLINDER IS NOT FIRNG, I HAVE REPLACED ALL THE PLUGS AND THE PLUG WIRE ON THAT CYL.
STILL NOT HITTING.
WHAT SHOULD I TRY NEXT?
THX
this is ford taurus common failure like i said i had three they all went the same way. one only had 33 miles on it. ford forgot to drill a three dollar oil hole for one of the sprage clutchs.trannys ...
Hello I have a 2001? Ford focus problem. It is a manual not an automatic.
Today I started it up fine, backed out of my stall and drove to the end of my block, a trip of 50-100', stopping for t...
ford fuel injector system
I have a 96 Ford Van E250 and it is real hard to start the vehicle if it is not on the level. It will crank like crazy and then eventually start. Could it be the fuel pump??
my number one injector on a ford expedition wont fire up
Where is the ignition module located on my 2000 ford contour 2.5l DOHC?
thanks for the help guys
I recently purchased a `97 Ford Probe with a 4-cyl 2.0L engine. The car has a manual transmission. I bought it knowing it had an acceleration problem. Now I`m looking to fix it. It seems that it occ...
How do I remove the fuel tank on a 2000 Ford Contour? The fuel pump is bad.
96 ford explorer door ajar light stays on, all doors are latched properly
How do I change the oil pan gasket on my 97 ford aerostar. Its like it is almost off, but I can't remove completely. Thanks
The Content on this site is provided for general information purposes only. It can not and should not be a substitute for face-to-face professional advice. By entering this site you declare you read and agreed to its Terms, Rules & Privacy.
Copyright © 2006 - 2009 DIY Forums |
Sponsored LinksLatest Posts
|
more posts...