| Blogs | Forums | Photo Album |
fuel
... 2WD 4.3L with 111K miles. It was starting hard (2-3 long cranks to get it to start). I suspected the fuel pump (that was the problem the last two times it acted like this). I checked the pressure ...
I'm having trouble threading the fuel line back into the fuel tank of my Craftsman cahin saw. Do you have to disassemble the fuel tank or is there some "trick" to getting it to go back...
When replacing the fuel pump in a 1998 AWD Chevy Astro van, is it better to buy the fuel pump from the dealer or will other brands perform just as well? If other brands perform as well, which brand t...
I know vapor lock was more of a problem on the older non fuel injected cars with low pressure fuel pumps mounted on the block. With the newer cars with high pressure fuel pumps in the tank with the e...
opinions on fuel system cleaners. Many persons are graciously agree which Chevron Techron cocnenrtate cleaner is wondewrful & pouring a bottle of it in to the tank every 3k miles should be a pa...
1997 ford t bird with the v8 was running fine then stoppped and would not start. checked for fuel pressure and had none. checked all fuses and all good. Dropped fuel tank and checked power to fuel pum...
Thanks lex, I dropped the fuel tank and found that the fuel line going into the fuel pump was cracked and spewing fuel out. I had to get a new fuel pump to solve the problem but,,,,,you were essential...
I relaced the fuel line and filter on my Craftsman chain saw. There's no gas coming thru the line. I por a small amount of gas in the carberator and the saw runs but stop when the fuel runs out...
fuel pump keeps running after the ignition is turned off. i have replaced the fuel pump, fuel filter, ignition switch, fuel pump relay switch, and the oil pressure switch. after replacing the oil pres...
2001 Grand Am. Fuel Pump fails to start. After replacing fuel Pump, same problem. Now trying to turn key to on position until I hear pump sound. then starts ok. may take many minutes to hear the sound...
About two months ago the fuel pump on my truck stopped working for a short time. (Fuel pump makes an obvious noise when key is turned, but didnt this time) I had to go to work and some friends pushed ...
I have an ariens 724 and the I noticed that when I try to prime nothing happends.
I releaized that the fuel line is somehow off. I cannot see how to take it apart to get to where the fuel lin eis. Th...
In my experience i`ve repiarted the fuel pump once (1996) & replaced it once (2000).
The vehicle would not arguably start two weeks ago, after it had run fine to get to my destination, and on...
Hi, I have a 83 Ford ranger that when it runs out of gas the electric fuel pump cavitates and you have to bleed the air out of the system. Well latly the air keeps coming back and It will run for abo...
HAVE A SMALL CRAFTMAN CHAINSAW THAT I NEED TO INSTALL MISSING FUEL LINES. HELPING FRIEND. I HAVE INSTALLED LI INTO TANK WITH NEW FILTER DOES THIS LINE GO TO THE PRIMER BULB? THE PRIMER HAS AN INTAK...
I have a little craftsman chainsaw that needed a new fuel line and filter. I tried to thread the line back through the hole it came out of but it seems to disappear rather than showing up in the tank ...
...tar our car wont start suddenly and we had ot towed to the dealership who says its a 700 dollar job the fuel pump, we already have to pay 90 for there tests and they cant test anything else until the ...
...l threads about engine will not start.here is a quick test to detremand wheather it is a ign problem or fuel. most of the time it is a filter problem to prove this.at the truck garage we pickup cars o...
...at of motor oil or petroleum jelly the most recommended, for reinstallation back in intake manifold and fuel rail?...
I'M trying to replace the fuel filter on my 2001 ford windstar. can anyone tll me where its located?
show me a digram of the fuel line on craftman chain saw.
wearing goggles remove the cap on the fuel rail and press it in with a pencil with the ignition to on. if fuel comes squirting out then its getting fuel.
while replacing fuel pump assembly, tank shifted, broke off the plastic piece that the fuel intake snaps onto. Is there anyway to take that piece off the old one?
Parked the vehicle 2 months ago running fine. Now will not start. Have determined that lack of fuel is the problem. Added gas to "both tanks" without any luck. Spraying carb cleaner into the...
... little better, but not much. Eventually it quit altogether. Towed it home, then figured out it was a fuel issue because the injectors weren't spraying anything when I tried to start it. I rep...
If you do not understand fuel injection you need to stay out from under the hood. this is not going to work. ohms is the amount of resistance in a circuit. 1.9ohm allows injector to open at a certain ...
In the meantime i`ve an 83 MB 300D whitch I`m repeatedly thinking about using fuel additives. I`m mainly sincerely concerned with lubricating the fuel pump because of the mightily push of low sulfur...
What is the normail operating fuel pump pressure on a 99 chevy 350 vortec?
Should the pressue increase under a load?
Is it normal that the pressue should begin to bleed off within seconds of tur...
Ranger has been worked on 4 times by the same place in the last 4 weeks. The fuel pump has been replaced twice, as well as having a new fuel filter, relay, pigtail and wiring. New plugs and wires we...
Clean diesel is a partnership between cleaner ultra-low sulfur fuel, state-of-the-art engines and highly efficient emission control equipment to produce dramatically lower emissions.
Clean diesel fue...
The Content on this site is provided for general information purposes only. It can not and should not be a substitute for face-to-face professional advice. By entering this site you declare you read and agreed to its Terms, Rules & Privacy.
Copyright © 2006 - 2009 DIY Forums |
Sponsored LinksLatest Posts
|
more posts...