New Topic
 
  #47843 Posted 10 Months, 2 Weeks ago
mike norris
Fresh Boarder
Posts: 1
graphgraph
User Offline
 
i have a lennox elite series furnace model # G26Q3-1 the green light on the furnace says it is working fine but the furnace will not light up it just blows and blows and wont cut off some time it will start and blow heat for about 1 minute then the flames go out and the blower just keep running what can i do to fix it
Reply New Topic
  #48280 Posted 9 Months ago
spamtowntim
Fresh Boarder
Posts: 1
graphgraph
User Offline
 
The g-24 has a few sticky problems
1- is the rubber boot right off the draft motor, it is known to plug up with slime or gunk. it's needs to be check and cleaned with hot soapy water.
2- is the pressure switches, check and see if voltage is at both terminals
Reply New Topic

Related Posts:

The Content on this site is provided for general information purposes only. It can not and should not be a substitute for face-to-face professional advice. By entering this site you declare you read and agreed to its Terms, Rules & Privacy.
Copyright © 2006 - 2009 DIY Forums