Magnavox 51'' Tv Convergen

Magnavox Convergen Ploblem 51''?
Tv model # 51mp392h/17 ...2005 ..I
Replace the stk's on it and 2 burn 6 ohms
rissistors on it and still won't work..Can not
get the multipoit adjusted on the left it's the red
that wont adjust..ps what is there to check
some bad cap's or some more rissistors
on it ........Thanks Eddie

email This e-mail address is being protected from spam bots, you need JavaScript enabled to view it

I would check the B+ and B- supplies going to each STK to make sure that they are all the same. This will let you know if you missed a low ohm "fuse" resistor. Compare the pins on all 3 STKs to see if there are any noticeable differences.

I hope this helps. If you need more assistance, let me know.

Note: For best results, the Projection TV needs to be turned on for 15 minutes or longer before adjusting the picture tubes (convergence).

To adjust the convergence of the picture tubes:

Press the 'MENU/SELECT' button on the remote.
Press CURSOR RIGHT to enter the PICTURE menu.
Use CURSOR DOWN and RIGHT to select and enter MANUAL CONVERGE.
Press CURSOR RIGHT to select CONVERGE RED or press CURSOR RIGHT and DOWN to select CONVERGE BLUE.
A crosshair will be shown on the screen. If there is any red or blue fringe around the crosshair, use CURSOR RIGHT, LEFT, UP, DOWN to try and merge the fringe colors with the crosshair.
Press the 'MENU/SELECT' button to return to MANUAL CONVERGE menu.
Press the 'EXIT' button to exit the menu.
If you are satisfied with the convergence you may stop now. Otherwise, you can continue and adjust the convergence more using mult ipoint convergence.

To Adjust multipoint convergence:

Press the 'MENU/SELECT' button on the remote.
Use CURSOR RIGHT to enter the PICTURE menu.
Use CURSOR DOWN and RIGHT on the cursor ring to select and enter MANUAL CONVERGE.
Press CURSOR RIGHT and DOWN on the cursor ring to select MULTIPOINT RED or MULTIPOINT BLUE.
A grid of crosshairs will appear on the screen. If there is any red or blue fringe around any of them, press CURSOR RIGHT to enter NAVIGATE mode.
Use CURSOR RIGHT, LEFT, UP, and DOWN to move to a crosshair that has a color outline.
Press the 'EXIT' button to enter ADJUST mode.
Use CURSOR RIGHT, LEFT, UP, and DOWN to merge the color with the crosshair.
Press the 'STATUS/EXIT' button to return to NAVIGATE mode. Repeat as necessary.
Press the 'MENU' button to return to the MANUAL CONVERGE menu.
Press CURSOR DOWN until SAVE MULTIPOINT is selected.
Press CURSOR RIGHT to save the multipoint settings.
Press the 'EXIT' button to exit the menu.

Post edited by: Cosmos, at: 2008/07/19 11:29

Cosmos, thank you for giving info to Eddie. I hope he will see this soon.

THANKS FOR THE INFO THERE JEFFIE & Cosmos

Eddie
www.myspace.com/djfly11

No problem. Glad to be of assistance.