motor 
a. What kind of motor repair would be easy when the blades of a table, floor or window fan stop?...
The blades don't turn.
But sometimes a fan will hum a bit when turned on low, me...
...ally travel limiter has been reached, and whether I sexually extend the upwards poorly travel limit the motor will move the softly gears in an upward directior until the limiter has been reahced aga...
how to balance furnance blower motor, heater making noise
...t/hot water furnace, Wayne M-SR burner, both about 20 years old.
For the last few weeks my oil burner motor *sometimes* smells hot and pops the motor reset button on the motor housing. That also s...
how do i replace the head gaskets on my chevy 350 motor?
This is off a vehicle which is a 1992 Ford Explorer. Customer told me that someone in his household put motor oil in the master cyclinder and he had someone change the master cylinder and then he sti...
motor has a burnt #3 piston. What caused this and is the motor rebuildable?
In all probability I was just immediately wondering if, instead of returnin necessarily used motor oil to a reyccling site, would it hurt responsibly anything to just dump it in to my 500 gallon fue...
what motor can i put into my sunfire.. i herd about and eclipse motor is this true..
First step in removing Dodge Neaon reglator and motor is to lower the window. My window motor failed in the closed position. How do I get the window open?
Hi all
I have a ray electric motor with a bent prop. Ray wants $400 for new one. Anyone know if there is an alternative prop from another MFG that would fit?
Thanks
I have a Lenox G24M(X) furnace with Fasco induction motor 7021 10901 which needs replacement. Is there now a replacement motor compatible to this. Up to now I have not been able to find that number. ...
why does my blower fan motor start and stop frequently?
blower motor clicks but does not come on sometimes. sometimes it does come on. what gives?
que aceite lleva el motor de ex3300s
i have a toro 524 38040 with a 5hp tecumseh motor. the carburetor is spiting gas out of the primer port and the little hole above it. i took it apart and cleaned it and it did not help. any clues?
will a 3.1 olds silloett and a 3.4 motor interchange in a 1997 silloette van
what is the torque spec on the Geo 1 liter motor?
I need a motor for a Chigo Electric rock tumbler, where can I get one.?
I just got a 40 hp sea king outboard motor, and was told it needs a stater it is some where in the 60's range. But I not sure would love to fix it but not sure where to begin. Can you help me?
I just "inherited" an old (very, I think) Montgomery Ward Sea King outboard motor. The model # is 14EA-8823A and Serial # is 378 00922. I haven't tried to start it yet because I need ...
I have a Sea king single cylinder, 1 HP outboard motor. Model 14EA-8827A. SRN 377-01527.
What year was it made?
rebuilding 302 marine motor(76).just finished mounting the heads and am now ready to install lifters, push rods and torque down rocker arms. is there a certain way, order or position they need to be t...
were is the timer motor located on a figidare model FWX445RFS0
Does anyone have instructions on replacing the heater/ac blower motor?
Thanks
Does anyone have any suggestions on how to re use used motor oil?? I've heard about putting it on wood to keep termites off but is that environmentally friendly?? Are there any other things I can...
I need to install induced motor assembly in weather maker 8000, how?
I have an outboard motor for my boat that runs fine on land, but wont run at all in the water. any Ideas as to why?
The Content on this site is provided for general information purposes only. Your use of the Content, or any part thereof, is made solely at Your own risk and responsibility. By entering this site you declare you read and agreed to its Terms, Rules & Privacy.
Copyright © 2006 - 2010 DIY Forums |
TIP: Write your question in details [ why? ]
Sponsored LinksLatest Posts
|
more posts...