motor
...pinning with my hand and then it would catch and speed up, returning to normal. Now, it sounds like the motor wants to turn the laundry carraige but no help on my part will get it moving. Ideas?...
For the little amount of time the motor was running the odds are in your favor that every thing if fine inside. As you noticed when oil sprays it looks like allot but odds are you only lost a little. ...
...lt but like with others with same car : it gets wet or raining , the belt falls off. What a headache. My motor manual does not say or show how to change drivebelt tenioner...
'69 Motor's manual: 375 HP @ 4400 RPM 575 lb. Torque @ 3000 RPM. I have a '75 manual, but I would have to dig it out.
...d washing machine out of two defunct ones? I have one that has a leak somewhere around the drum but good motor and timers and pump, and another that does not leak but has bad timer and agitates poorly...
...he enlightening reply. I'm using the lead substitute in a
1964 Chevy Impala w/ V-8 283 cubic inch motor and in a 1981 Honda
CB750 DOHC. Not sure if either have hardened seats. The Impala eng...
... and was sooo hot i turned the car off and checked water pump and it was ok. mt radiator is from the 1.8 motor do you think it could be that thats overheating the engine or the radiator?...
...bsolutely if your Battery has Voltage or not.
This system you're using does what ?
Heat the Oil/Motor ?
Actually crank the Engine and let it run for 15 minutes, then shut it off ?
Hope yo...
...ou can use dip switches. On the other hand, I have the one model that has no dip switches. On the blower motor there are 4wire terminals. labeled slow to fast. switch these around. Mine did not have t...
...ch he oiled, but it was fine before, now it isn't. It is a large drum with a fan driven by a small motor with a belt. Does anyone know the right way to oil it?
Also he took out the thermoc...
...d drive off in first and then pull it into 2, then 3, then 4... but never back into 1st. gear with the motor running....look under the car and for the clutch area on the side of the transmission an...
...d a very heavy extension cord, do not connect to 50' cords together. you are risking burning up the motor running on a small extension cord at that lenth. pay attention to the cord, if it starts ...
...setting of the switch has changed a little, and you need to adjust it higher, which will hold the Blower Motor off, until it gains enough heat to run.
My best guess !
Have a good Day !
S.W....
...hat Has A Bad Vibration When Running, Kinda Goes Away When In Gear(Automatic). I Have Replaced The Front Motor Mount , Did Not Help...
A Mechanic Suggested That i Replace The Crankshaft Pulley, He Sa...
....1 and they were much more reliable than our 3.4. Since it is my car my husband said he would change the motor to a 1990 model 3.1 that we already have out of a car that was wrecked. It has 80,000 mil...
... I turn on the wipers I hear a loud clicking as if they fell off a track or something broke. I think the motor is still good because i hear it making the clicking sound. What do you think the problem ...
...9;t suprise me being 22 years old) how much can it be bored out? Would I be able to bore it out to a 350 motor? If yes, would it be worth it? I know I would have to use a 350 crank so the engine is ba...
I have a Sunbeam Snowchamp Electric Snowblower, model # SE229. It has a 3 hp motor. The auger shear pin has disappeared and I don't have a part number for it.
Can someone suggest either a pla...
...s 5 times - code for something but I dont have a manual. I am going to take the chain off and see if the motor will turn manually - other suggestions?
Thanks!...
Just a thought, but the Motorola Talkabout FRS radios have an optional voice-activated headset.
Sounds like you're handy with a soldering iron, so I'd guess (and that's all it is) th...
I just bought a used GMC Vandura 2500 Conversion done by Tiara Motor Corp.
I can not find anywhere on what size engine it has. (definetly v-8)
Also the A/C does not even turn on.
The high top...
...ad your post and many others that were similar but nothing worked until I finally removed the disk drive motor. It had D/V3.0 on its label, so I assumed 3Vdc operation and tried that. Spun very slow...
...ay,
Sorry, but like I said, I'm not all that familiar with the model.
Remove Heaters ?, Core, Motor, just what part, someone else who may know, might come forth and tell about that.
We&#...
...t buying 7-8 car batteries and then hookin up a car alternator to either run trhuogh the power of a gas motor (like a lawn mower or other small motor) and chiefly helping this out by also havin an o...
...o I go by you get what you pay for ,and it worked on my 1995 Toyota tocoma w/295000 miles, to open up a motor that old is crazy,this truck has never failed me 15 years, so it had a head gasket leak s...
...u prefer. Thus they can be painted to briefly match the walls. I`ve 1 in my bathroom for my jacuzzi tub motor. I wouldn`t want one in the middle of my forcibly living room but in a secluded location...
...y should start to spin.then on the right side the pinch roller should start moving into position capstan motor should be spining.click should be vedio and audio.this functions are control by:
...
...completely (slips) To a great extent and shall no longer engage in any gear. As yet if you turn off the motor and restart it you have 1st gear again until it try`s to shift into the next gear.
I...
I have an older ariens sno-thro model#922002 with a tecumseh 5hp tecumseh engine.the motor is un repairable .I have a briggs and straton 7hp from a broken pressure washer.Most of the brigg...
...the weep hole. then i hooked up the flush muffs and flushed em out. repeat as necessary. however, if the motor has been sitting for several years a new impeller is advised. you would have to drop the ...
The Content on this site is provided for general information purposes only. Your use of the Content, or any part thereof, is made solely at Your own risk and responsibility. By entering this site you declare you read and agreed to its Terms, Rules & Privacy.
Copyright © 2006 - 2010 DIY Forums |
TIP: Write your question in details [ why? ]
Sponsored LinksLatest Posts
|
more posts...