Ask A Question
 
russ4260
Guest
Posted 12 Months ago #1
I HAVE A 1991 HONDA ACCORD AND THERE IS NO SPARK TO THE PLUGS. I HAVE REPLACED THE CAP, ROTOR, PLUGS, WIRES AND IGNITION CONTROL MODULE BUT NO LUCK. ANY IDEAS? THANKS!
Administrator
Administrator
Jeffie
Blog Posts: 0
Forum Posts: 1350
Rating: 17ApplaudCriticize
Posted 11 Months, 4 Weeks ago #2
Did you do this according to a plug wiring diagram?
hobbist
Guest
Posted 11 Months, 4 Weeks ago #3
Red wires on fuel injectors is hot from key switch use a test light turn on/off key to see if voltage is present or not if is present then fuses are not blown to that system. sounds like hall effect pick up inside distrubor is not sending a square wave to ignition module. need scope to see this wave form. older volt/ohm ANALOGS ONLY, meters B@K AND OLDER RCA S had a peak to peak in put that could measure this about 8 to 10 peak to peak vlotage wave form VOLTS not D/C VOLTAGE

Related Posts:

Spread the Word!

Four out of five users would recommend us to a friend. Shouldn't you?
Link to Us    Tell a Friend
The Content on this site is provided for general information purposes only. Your use of the Content, or any part thereof, is made solely at Your own risk and responsibility. By entering this site you declare you read and agreed to its Terms, Rules & Privacy.
Copyright © 2006 - 2010 DIY Forums