|
|
| |
rdpar
Fresh Boarder
Posts: 4
|
|
I have a red shadow pn the left side of the picture. I tried to align it with the remote but the red did not move. There is a little black box inside the back panel with 6 knobs on it could this be another adjustment for this problem?
|
|
Reply
New Topic |
| |
lagacyj
Expert Boarder
Posts: 96
|
|
Im not sure onthe pioneer model numbers.but if your trying to move the red I would have to say this is a resr projection t.v.which in case the convergence does not move means you convergence amps need reeplacing and maybe some fuses.
|
|
Reply
New Topic |
| |
rdpar
Fresh Boarder
Posts: 4
|
|
yes it is a rear projection tv. And I was afraid I would hear that response but thanks. If I new what and where it was located i could replace it my self. Oh, does this tv have any danger spots where high voltages are stored in a capacitor or something that i should be aware of? Thanks
|
|
Reply
New Topic |
| |
lagacyj
Expert Boarder
Posts: 96
|
|
yes there are high voltage spote to beware of in the t.v around the flyback and yoke plugs.but with the t.v unpluged for a while you shuld be o.k. not sure wee the stk i.c. are on that model but there easy to find.there the big i.c.on the heat sink there is usually two of them replace them both
|
|
Reply
New Topic |
| |
hobbist
Guest
|
|
this tv is a mitsubishi.it is noted for bad solder under deflection board around flyback theirs a STE130VOLT DC 5 AMP REGULATOR GETS HOT LOOSENS UP SOLDER.look with magnafi glass you will see solder rings.also their are two large str or stk packs.one is vertical the other is convergence.see how hot to touch they are getting.they may be going bad unplug tv before doing feel test.use temp control soldering iron with needle tip do not over heat board or your are finished damage board your all done junk.new board if avaible starts at $400.00.been their done that.lost money that day on that jod.
hobbist tv/appliance repair 42yrs retired.binghamton n.y.
|
|
Reply
New Topic |
| |
rdpar
Fresh Boarder
Posts: 4
|
|
you say this pioneer tv is a mitsubishi?
|
|
Reply
New Topic |
| |
hobbist
Guest
|
|
Their is only one or two mfg of rear projection tvs.pioneer and many brands are companies own by investers.pioneer is long gone as poineer.check internet your will fine who really owns pioneer.many buy from suppliers to cut cost.
|
|
Reply
New Topic |
| |
rdpar
Fresh Boarder
Posts: 4
|
|
you wouldn't have a picture of them would you. I don't see anything attached to the heat sink.
|
|
Reply
New Topic |
|
The Content on this site is provided for general information purposes only. It can not and should not be a substitute for face-to-face professional advice. By entering this site you declare you read and agreed to its Terms, Rules & Privacy.
Copyright © 2006 - 2009 DIY Forums
|
Moderators Wanted!

We are looking for volunteers to join the moderation team.
If you want to take an active part in our community, while helping others please
send us a note.
|