pressure
... right.
As long as the thermostat can see coolant, it will open at the correct temperature regardless of pressure in the cooling system.
Overheating only at idle would tend to suggest an airflow...
be ware that fuel pressure can be zero in ignition module is bad the way i tested my pumps is turn on key you should hear relay click then brrrr noise the pump runs for a few seconds then stops.(turn ...
how much can I paid for replace my 1" Wilkinis pressure regulator
...irs a fuel schreen up were fuel line connect to fuel rail.
three you have to determand wheather its fuel pressure problem or igination module (spark failure) problem. to determant its not module pr...
Have you changed the throttle position sensor?
Or how about testing fuel pressure.
...oo much air)
4) Dirty oil nozzle
5) clogged oil line strainer at pump
6) dirty oil filter
7) low nozzle pressure (adjust)
8) motor and/or wiring problem resulting in low RPM ( and low oil pressur...
what might cause the steering fluid to spill out the cap as if a pressure backup?
I have a leaking head gasket. the leak is not big but causing a pressure build up in coolant reservoir and some water droplets coming out of exhaust.
My options are
1> thermalweld
2> steel ...
i concure with jman if fluid is disappearing chances are you need clutch throw out bearing, clutch and pressure plate. the travel in ram is to far by pumping clutch your pre filling oil line and runn...
...and this would have been part of that job.
Leaking after about ten miles, my first thought was crankcase pressure. You said you replaced the 'breather tubes' But....?...
hI Dewitt Hamilton, welcome to the forum
I advise you to have the fuel pressure checked
I suspect fuel problem. Injectors (leaking), pressure regulator (not holding), pump.
Davecd17, I think you need an plumber with pressure measuring equipment to find out where the problem is situated.
overcharging an HVAC system with refrigerant will cause the head pressure to be higher or lower than norm.
Have you checked the fuel pressure?
Or if the TPS reads correct, and coolent temp sensor.
FILTER BACK BY TANK UP IN FRAME.I THINK ON DRIVERS SIDE.LOOKS LIKE A SMALL WELL HOUSE PRESSURE TANK SMALL SIZE.NEED SPECIAL TOOL TO RELEASE FUEL LINES.
...ome to a stop if not.you my have a fuel flow regulator or pump or injector leaking presure is not coming to pressure.or a bad relay under hood black electrical box on fire wall.i own a 88delta it cran...
If you were to check your well tank for pressure and water comes out of the air valve stem Is that a good indication it is watterlogged and needs replacement?
...hole that will accept a ratchet (3/8" handle. It will be spring loaded toward the belt, so just apply pressure in the opposite direction....
is it a slow leak or does it keep filling up at full pressure. check the fill valves they could be stuck letting water in
not all controls do. The main burner flame size can only be adjusted by varying the pressure regulator setting (in the gas control). Unless you have the precision measuring gauge and know what yo...
under the truck driver side, about under back door.shape like a well house pressure tank.need special tool to release connectors holding the tubing.
Thank you for your help. I turned down the pressure as you suggested and thinned the paint. It is working a lot better. I guess we will just have to keep going until we learn how. It is not as eas...
where is the fuel pressure regulator on a 1996 f-150 ecoline 302 ford van located?
... boggled so he contacted Carquest tech line. We ran a number of tests. We checked the intake manifold for pressure leaks. We tested the pressure in the fuel line. We did a compression test, we chec...
Plugs, injectors, pressure regulator, dirty fuel filter, wires crossed, any one of as many as a dozen sensors, etc., etc., etc. Lack of candy and flowers.
cant someone plaese help me. my rst has a lot of pressure in the header tank when engine is runing and after turnd off. i think its a head gasket but not sure. even with the fan cutting in it still ge...
...about twice as heavy as the new one, must angrily have been the water deposits in the tank??? In short the pressure relief valve is probablly optionally blocked open by the sediment thats totally tr...
...the timing belt/chain not properly installed? It is also advisable to check your compression and fuel pumpt pressure ...
remove the cold water hose and see if theres good pressure coming out of the hose. if there is then the problem could be the fill valve is clogged.they have a screen to keep out junk and that might be...
The Content on this site is provided for general information purposes only. Your use of the Content, or any part thereof, is made solely at Your own risk and responsibility. By entering this site you declare you read and agreed to its Terms, Rules & Privacy.
Copyright © 2006 - 2010 DIY Forums |
TIP: Write your question in details [ why? ]
Sponsored LinksLatest Posts
|
more posts...