problem
Gas furnace question/problem
-------------------------------------------------------
-------------------------
my son has G.E. gas furnace in his attic. he has recently had work on his home whi...
kad,
No problem on the Language, Electrical Schematics are the same in any language.
On page 32, find the Fuse #2.7.
This appears to be the line for the internal sensor circuit.
I'd ...
Hi, I had the same problem with the slipping CVT M6 tranny and it being stuck in one gear only when the got hot. I had the TEC heads scan the tranny 'low and behold' in the temporary memory ...
My house was built in 2001. I haven't had any problem with the electrical plug in my master bathroom until today. I have power to both light switches (neither of which controls the plug) and al...
...lcome to the Forum!
Sorry that we didn't get a report back from COArsneal on the fix for that type problem, my thought would to be just replace the Unit.
Sometimes just cleaning (blowing th...
i have a 1987 sylvania 42 widescreen. im having problem with convergence. where is it located and look like?
I HAVE AN 89 S-10 P/U WITH THE COMMON PROBLEM OF WIPERS GOING ON WITH THE HORN OR TURN SIGNALS OR WHEN EVER THEY WANT TO. HOW DO I REMOVE THE STEERING COLUMN TO MAKE THE REPAIRS?
...TF. Can the bands be adjusted externally? If so, how? Can anyone think of any other idea to correct the problem?
Cbull...
hello...sir...i have Sony DCR-HC21E handycam...problem is that the touch pannel on lcd is not working..what can i do???
Id appreciate any comments from this group on my problem. Apart from my old car`s engine, I didn`t see much of other car mechasnics, and expertly have not had practice in a garage. I drove my new ...
need pic of weathermaker8000 carrier gas furnace,trying to help someone w/heating problem and hes not that mech. inclined
... look. No foreign cars.
Fluid and filter changed reg,fluid level on the money, sounds like an electrical problem to me. I reset the computer, by removing the neg batt cable, and 5 min later reinsta...
...re that you've turned the Breaker off at the Panel first, then proceed to check, tape and isolate the problem area.
Re-Set the Breaker, and try it again.
Have a good Day !
S.W....
Our home was constructed in 2000 and we haven't had a major problem with the central a/c yet, had to replace a solenoid a couple of years back is all. But yesterday the outside unit quit working....
I've got a '96 delta 88. The transmission has a problem. It will allow you to put the car in gear, and it engages in gear. When you give it some gas you can tell the engine is under a litt...
...ustomer.He has been driving now for almost 2 weeks with No complaints so far.
Can you let me know if your problem has been solved.
Thanks
Pierre...
Is there any advantage to using Cabot Problem Solver alkyd primer and Cabot latex deck solid color deck stain over Oil dec stain? Which is beter? Or, what is best?
I've read many of the complaints regarding the remotes but have yet to see my particular problem...We moved into a house in '06 and within that year purchased 2 new craftsman remotes. Only ...
If the machine is between 3 to 5 yrs old the machine water pump may be the problem theirs several rubber check valves that distort from hot water over several yrs..i think total pump replacement is re...
...us commands but the motor does not run. I have a service manual but I don't see any sections for this problem.
Thank You...
...te tv and no joy. Bought a universal remote today which wont make it work either.
I figure it's a problem with the infrared sensor on the actual tv so I took off the plastic thing on front an...
... throttle positioner accerlator dash pot.then chrysler famous fuel pump failure last thing.you have a flow problem.one other thing possible thing is plug cat or converter in the exhaust....
I have an Toro S620 Electric Start Snowblower and when I go to use it to blow snow the paddle just stops spinning and won't move the snow practically at all. The belt appears to be ok. What cau...
does anyone have any suggestions on what could be wrong with my snowblower its an ariens 824.starts up runs on high idle
then starts to die then will catch again
on high idle then start to die.
...h works.if i hole a screw drive in the switch slot to let wasing work with the lid open it works.only spin problems only 3 years old....
Whenever I look through the viewfinder, all I get is a washed out negative view. I see two little buttons on the bottom of the eyepiece that say bright and contrast, but they don't seem to affect...
Hi, I have a 83 Ford ranger that when it runs out of gas the electric fuel pump cavitates and you have to bleed the air out of the system. Well latly the air keeps coming back and It will run for abo...
I have a Magnavox projection tv 51mp392h/17 that shows a green red effect on the screen and shows double. What could it be?
I have an Akai GX-215D Reel to Reel tape deck.
The capstan will turn at 3 3/4 speed but not 7 1/2.
Any suggestions? Is it a cheap/easy fix?
my tv is showing 7 or 8 horizontal white lines across the top of the picture, and I was wondering if there is an easy fix for this, I,m no electrical genius, but I,m willing to try just about anything...
The Content on this site is provided for general information purposes only. Your use of the Content, or any part thereof, is made solely at Your own risk and responsibility. By entering this site you declare you read and agreed to its Terms, Rules & Privacy.
Copyright © 2006 - 2010 DIY Forums |
TIP: Write your question in details [ why? ]
Sponsored LinksLatest Posts
|
more posts...