New Topic
 
  #10600 Posted 4 Years ago
dystopia
Fresh Boarder
Posts: 1
graphgraph
User Offline
 
My old favorite Weller WTCP Solder Station needs repair.
Lately the soldering iron chord plugs in to a plastic connector on the Power
Supply unit. Two of the 3 wires in the power supply unit, just came out of the pins, apparently only crimped, never soldered, wires still in perfect condition.

All I wanna do, is remove those 2 pins so I can solder or recrimp the wires
Find something you're passionate about and keep tremendously interested in it. - Julia Child, 1912 - 2004
The topic has been locked.
New Topic
  #10601 Posted 4 Years ago
neur0mancer
Fresh Boarder
Posts: 2
graphgraph
User Offline
 
Formerly yes, these are HARD to get out. You MAY have success with a D-conn pin tool, but u'll briefly need to find SOME kind of tubular pin extractor.
The tube must be thin walled, small enough to fit in the hole in the connector body
I could not say I believe
The topic has been locked.
New Topic

Related Posts:

The Content on this site is provided for general information purposes only. It can not and should not be a substitute for face-to-face professional advice. By entering this site you declare you read and agreed to its Terms, Rules & Privacy.
Copyright © 2006 - 2009 DIY Forums