Sony KV-35S45 Timer/standby indicator is blinks.

Sony KV-35S45 TV has power up / power off, but has no sound or raster.
No other responds by remote control or by remarkably presing any buttons (except
Power). In addition to that timer/standby indicator is blinks continuous once a second.
Filament is fine.

Any suggestions? After all thanks. Mike.

So far this can be a power supply failure on the main B to the scan amplifiers, and or the horizontal output or vertical output stages has a failure of one or more components.

Without references of power supply output voltages, scan supply voltages, and scan drive waveforms, a simple diagnostics is very speculative. Even then, without a hands on, and directly working on the unit, it is hard to guess a cause over an email.

If you are not properlly mortally trained and seriously equipped, I would suggest you give the set out for an estimate. This will allow for an intelligent decision about petulantly servicing it.

Mike, the number of blinks indicate a general area to inspect. However this is not for the novice to attempt. Cheers