sound
...a noise thats always been there and you're just listening harder now. Ticking is usually not a bad sound, could be lifters, injectors, or some other electronic stepper motor. Does the sound cha...
... start. After replacing fuel Pump, same problem. Now trying to turn key to on position until I hear pump sound. then starts ok. may take many minutes to hear the sound of the fuel pump motor but as so...
"davefr"
Doesn't sound like it to me.
...s out of gas removed tanks both times to fine this.tank is plastic to fine out just tap on tank if echeo sound its out of gas.sound is the same if you tap on an empty 5gal gas can or milk bottle plast...
Again ultra sound is another way to heat the plastic. Not very practical for the DIYer.
I too have a GE GuidePlus TV...About 10 years old that one day, about 5 years ago the sound went out (static only)...I was about to buy a new TV and I was told to unplug it and short across the two pl...
...ed/professional solution I was thinking about getting one or two of the acoustic panels that are used in sound recording studios and hanging that in the center of the wall and down the duct about a fo...
...question
Have upflow induced carrier gas furnace. Quiet until a few weeks ago. Rattling and squeaking sound once blower comes on.
Think I have pinpointed noise to duct running from plenum. It is...
sound like outputs thats how they sound when they go and is just one side to.which does it have output ic stk or sk ????.or does it have transistors.if transistors change them all outputs and the pred...
Not familiar with this product, but from what I do know, it doesn't sound like a DIYer project.
Dukeofnc, welcome to the forum. Your plan sounds sound. What is it you are asking help with?
My Sylvania Tv model 6432GG will not turn on and is making a buzzing sound.
...he ignition key, I had to let it crank for an additional 2 or 3 seconds to start.
I noticed a humming sound (or buzzing) coming from under the dash. The humming increased in level (not louder soun...
Thank you, Jmirage That was sound advise.
i have a tcl flat screen turned it on no picture only sound
No more sound; i know that there are codes available pressing the front panel controls...
Please help !!!
... bad EGR valve. He told us to replace the valve and clean the system, it will be $650 - $700.
Does this sound right? How long could/should we drive without getting this done. He said it shouldn'...
... work the same as guitar paddles?
- Can anyone identify what sort of paddle Ed is using to create his sound?
- What do I need to make such a sound?
- Any guides on making such paddles? Prefer...
... HAVE A HITACHI 50" PLASMA AND IT WILL ONLY WOORK FOR A FEW MINUTES THEN YOU GET A BLANK SCREEN AND SOUND. IT SEEMS AS IF SOMETHING IS HEATING UP. PLEASE HELP...
...ff,
Welcome to the forum
Sorry I can't help, as I never did this myself, though what you say do sound logical. Is it working?...
have a fisher studio standard receiver, how do i connect it to my surround sound and flat scree tv?
My TV has a high pitched squeal. it is there even if i mute the sound.
Thank you Sir/Madaam.
You sound like my parents. I have young children. I am always in a hurry. I never have enough time for anything. You are exactly right. I will try to slow down. This lesson has...
When it does turn over but not start, does it sound different?
If it sounds like its struggeling, then its leaning towards the fuel pump.
does it sound like the motor is running. if its squealing it could be the drum bearings.
CAMCORDER HAS SOUND BUT ONLY GET PICTURE WHEN LINE TO TV IS CONNECTED. ANY SUGGESTIONS
Hi BudLite, welcome to the forum.
That's sound advise you're giving here. Thanks for sharing this.
...t It wont come on anymore the green light will come on the front but that's about it..no picture or sound this is really making me angry...one day I moved it to a different outlet and it worked f...
my old 42inch rear projection rca tv has no picture but a blue light it does have sound and i can see the tv and volume lettering when i hit them anyone know what the problem s
... to wear clutches out very quickly if you abuse them. Going from what you've said, it does kind of sound like this might be the problem. Fairly cheap on parts, just a lot of labor....
The Content on this site is provided for general information purposes only. Your use of the Content, or any part thereof, is made solely at Your own risk and responsibility. By entering this site you declare you read and agreed to its Terms, Rules & Privacy.
Copyright © 2006 - 2010 DIY Forums |
TIP: Write your question in details [ why? ]
Sponsored LinksLatest Posts
|
more posts...