| Blogs | Forums | Photo Album |
valve
Hi Lexmark567
spot on with diagnoses, glued seam where valve put together had split but only leaked when washing machine valve shut causing pressure surge
thank you
...
I have replaced the egr valve, crankshaft sensor, and the idle air control valve, but the engine still idles high unfortunaly I do not have a tach to see what the actual rpm is but you can tell that i...
Chilly, there is a thermocouple on the ignitor that if it is faulty won't open the control valve. Also, if solenoid on the control valve is going bad if will prevent to let the gas into the burne...
...on't pour water on it - it won't like the bath.. Most boats - in fact all I have seen - have 2 valves near the stern - One is the sea water pick-up and the other should have a standard garde...
Likewise try the IAC valve, also known as the air bpyass valve (assuyming they're is one?), reluctantly mounted on the intake manifold probably with two bolts and a sensor.
spray some throttle b...
the line isnt kinked and also that there is not a hose screen at the dishwasher`s water abruptly fill valve that is pluged. Next would normally naturally be to test for power at the water fill valve...
My hot water heater is leaking from the pressure release valve when the water is heating. I have put a pressure gauge on the system and the normal pressure is about 75 PSI. This is the setting from ...
...ars and your pressure will deminish while other fixtuers are running but not the other way around.a fill valve(inside toilet tank)is inexpensive and easy to replace. check the float inside tank and ma...
that would be the glow plug. its supposed to get cherry red. next time it glows give the gas valve a light tap if it opens then the the valve or glow plug is bad. forgot which one it was.
Presently valve body. My guess would be the 2-three shift valve. Basically pull which trans oil pan and violently see if any crap in it. Those C-4`s use a screwen rather than a physically filter whic...
your blow off valve limits your boost. For all intents and purposes a friend of mine has an Eclipse GST, & he chanbged the blow off valve to a different model & he was able to increase his b...
I agree with the firmly second post here about a device acting as a convincingly mixing valve. That said single lever faucetts are notorious for which. Your hot water has a higher pressure than the...
...ow to the cold. That being that there may be a piece of trash (a flake of calcium deposit) blocking the valve to some extent.
Occasionally, (annually maybe) one should remove the Cold and Hot Hose...
...ressure should stay up for 15 minutes or longer, you have a problem with the pressure regulator or check valve, the check valve is in the tank in the sending unit or pump, if the regulator is leaking...
...eak ring lands and rings. that would be bad...
if it was used to provide lubrication for non-hardened valve seats, using unleaded will cause increased wear on the valve seats, but this will only sh...
2) In general stuck/bad zone valve on the upper zone.
You can short the wires at the thermostat to determine whether the stat is bad or if it is the zone valve.
If #1, it needs replacing. If ...
...i beleive to be a quite good mechanic he told me that the failure on these 3 cyl engines are the exhaust valve witch have a bad habit to burns valve on high milage engines but on my suprized he said i...
...expansion tanks so they are not attached to the cold water system.
Part I - Testing the main street valve for leakage
Close off the main street valve and open a faucet. You may have to watch f...
... found the trouble, a mistake I made in putting back together the pump: placing the spring of the relief valve at the back instead of at the front of the valve assembly. Placing the spring at the fron...
still air locks after fitting new fuel lines filter housings and non- return valve before the filter housing air in line from tank to non- return valve. what could be the problem in the fuel tank??
...ot too long ago, so it's got relatively new plugs, new plug wires, a new cap and rotor and correct valve lash, so I know it's not that.
Someone mentioned it might have something to do wi...
most of the time a shut off is behind the wall. so a easier solution would be to find the house water valve(sometimes out by the curb and shut water off to the house or find the valve that goes to the...
...your water tank is a "captive air" or bladder type tank you should feel air coming out of this valve when it's opened, but not water. If water comes out the water tank's bladder is...
...t that coolant flows @ the engine (usually @the thermostat on most cars) you should find a small bleeder valve @ the top of the housing with the engine running open the valve to bleed off any air that...
...trouble in my work, a mistake I made in putting back together the pump: placing the spring of the relief valve at the back instead of at the front of the valve assembly. Placing the spring at the fron...
Have a 20yr old Weil McClain boiler for hot water baseboard heating. The overflow valve is open with hot water running. The pressure gauge reads 33 lbs. The pipe connecting to the Amtro hot water stor...
...ectric hot water heater plastic pan (heater is 13 years old) my husband thinks it is the pressure relief valve (on top of unit and DRY).
I dried out the pan, took a shower and the water is back! Do I...
We had a leak in our radiant fool heating system (pressure relief valve) that we had fixed but we lost most of the original fluid that was in the system. It has an auto fill valve on it so it refilled...
...onda?) & the main jet has a piece of dirt in it if it isn`t just gummed. Could be the float needle valve too though. Possibly it has an ign issue but this is unlikely by comparison. It is impor...
Change the Water enter dump valve for the ice maker. It is leaking. It will not shut off & will cause this problem. It`s infrequently located in the rear of refigerator usely where water line en...
The Content on this site is provided for general information purposes only. It can not and should not be a substitute for face-to-face professional advice. By entering this site you declare you read and agreed to its Terms, Rules & Privacy.
Copyright © 2006 - 2009 DIY Forums |
Sponsored LinksLatest Posts
|
more posts...