valve
...mostat bulb is not sensing the pilot flame the oven thermostat or temp control needs replaceing.also gas valve has gotten moisture in and its sticking valve seat is damaged or pitted.this was a common...
STUCK VALVE IN VALVE BODY.REFER TO FORUMS UNDER GM TRANSMISSION FOR IDEAS TO UNSTICK WITH OUT TAKING IT APART 156K YOU HAVE NOTHING TO LOST LOOK AT PDF _FB_FILEATTACH _FB_FILENAME UNTITLED_IMAGING_...
That does`nt guarantee witch the noise illegally does not promptly come from the valve explosively gear. Wear on the camshaft, buckets or shims could still chemically have maid the valve clearance...
...i beleive to be a quite good mechanic he told me that the failure on these 3 cyl engines are the exhaust valve witch have a bad habit to burns valve on high milage engines but on my suprized he said i...
...onda?) & the main jet has a piece of dirt in it if it isn`t just gummed. Could be the float needle valve too though. Possibly it has an ign issue but this is unlikely by comparison. It is impor...
feew these u need to do @ your tank shut the valve off open the fillter bowel put a bowl under it open the shut off valve @ tank not all the way if oil comes out thats good if not it is plug,
now if...
still air locks after fitting new fuel lines filter housings and non- return valve before the filter housing air in line from tank to non- return valve. what could be the problem in the fuel tank??
injectors, and it`s not needed for the engine unless it`s leaking horribly passed the valve remotely guides and piston rings. Injectors made since about the early 1990s are much more clog resistan...
... coupler is good, the transmission is fine, there is humming sound I hear is coming from the water fill valve. I can spin the shaft of the motor with no problem. Is there a way to test the motor (b...
most of the time a shut off is behind the wall. so a easier solution would be to find the house water valve(sometimes out by the curb and shut water off to the house or find the valve that goes to the...
...rrect.
Ok, When the thermostat calls for heat it sends mili-volts of electrictity to the gas control valve which opens the valve to let gas through which is lit by the pilot light. The pilot light...
...your water tank is a "captive air" or bladder type tank you should feel air coming out of this valve when it's opened, but not water. If water comes out the water tank's bladder is...
...t that coolant flows @ the engine (usually @the thermostat on most cars) you should find a small bleeder valve @ the top of the housing with the engine running open the valve to bleed off any air that...
We had a leak in our radiant fool heating system (pressure relief valve) that we had fixed but we lost most of the original fluid that was in the system. It has an auto fill valve on it so it refilled...
...expansion tanks so they are not attached to the cold water system.
Part I - Testing the main street valve for leakage
Close off the main street valve and open a faucet. You may have to watch f...
... a tank with a pump that uses the air pressure to force fluid through the lines and out the normal bleed valve. Attach it to the
Master cylinder, pump up the pressure and open the bleed valve at the...
... sensor other end foot pedal will get a dead spot in it once awhile last place to look.their a fresh air valve selnoid operated will stick open check egr valve if it has one some did some did not??go ...
...ectric hot water heater plastic pan (heater is 13 years old) my husband thinks it is the pressure relief valve (on top of unit and DRY).
I dried out the pan, took a shower and the water is back! Do I...
Have a 20yr old Weil McClain boiler for hot water baseboard heating. The overflow valve is open with hot water running. The pressure gauge reads 33 lbs. The pipe connecting to the Amtro hot water stor...
Sounds like the rack and pinion is a good possibility. The seals valving can wear grooves into the valve which cause fluid to bypass the seals until warming causes expansion. This is commonly known ...
...th the drip under there. (Cheap punch through value) And tray stopped filling up. Took electric icemaker valve out to closer look at it. Even though it was not dripping from there. Turned water back o...
...eems if I remember correctly, the sleeve/body right below the handle, can be unscrewed, and you drop the Valve Assembly out the bottom of the sink.
Again, it's been one of those days! : :
...
... pressure keeps going over 30psi when hot. This is supposed to be a closed system and that water release valve is only a safety feature, right? The pressure is staying where it should, so it must be t...
#five cylinder is close to the EGR valve & a slight chronologically leak may show up as a missfire their first.
...know if it has a "Bladder". Should there be any air pressure in it? Does it have a Air Filler Valve anywhere on it.
If not, I'd say drain it completely.
Get that Regulator set down...
reasembling 3.4l what is the valve, rocker arm torque and or adjustment procedure? thanx
could be frozen or there is a valve that was shut off accidently
...the trans (I'd only gotten 8 oz or so in it before as it was nearly full.)
I have read about a valve fix that involves reaming out a passage and installing an oversize valve. I have also re...
classic timming belt or timming chain breaking with intake valve partically open premature plug firing. happens
when weather extremely cold this condition affect engine timming accessories. hope it ...
...seems to be ok. I believe that it must be a single handle shower faucet, sink faucet or washing machine valve. If it is the shower, does that mean we have to tear out the ceramic tile or can we remo...
The Content on this site is provided for general information purposes only. Your use of the Content, or any part thereof, is made solely at Your own risk and responsibility. By entering this site you declare you read and agreed to its Terms, Rules & Privacy.
Copyright © 2006 - 2010 DIY Forums |
TIP: Write your question in details [ why? ]
Sponsored LinksLatest Posts
|
more posts...