valve
you can hear the click on the valve opening when the thermostate is on but the damper goes right around and closes and the boiler don't kick on or somethime it comes on and the water heats up to ...
..., then it must be a case of water not getting to the cube tray. Could be a plugged line or bad solenoid valve.
Just came in from a service call where the trip arm had come out of the switch, so th...
... could be air-locked and would need to be bled. If that is the only baseboard unit in the loop, the zone valve may not be opening. Not enough info to accuratly diagnose your problem....
do you have spark. to check for gas there's a valve you depress on the fuel rail. WARE GOOGLES . if fuel squirts out then its getting fuel. makes ure the engine is set to on but not start so ...
...ll absolutely positively fail an emissions test, not to mention the crap that's building up on your valve seats. If you don't address it, you'll probably have to replace the cat as well...
...dditional info at http://www.carrepairestimator.com/car-repair-estimator/
Toyota/camry-2009-to-1989/egr-valve ...
hi guys,
in the 70's gm had problem with the way heads were drilled. oil fouling can be caused by valve seal but real problem is the guide is drilled off.
... and has lost some of its power. I have changed the spark plugs but that didn't help. Could it be a valve adjustment problem or??
Thanks
Don...
... problem and it was out of gas IN the carb.
The jets clogged and after noting the setting on the needle valves, I pulled them out and then gave the primer bulb 4 vigorous pumps and gas squirted out o...
Our toilet faithfully started itnermittenlty explosively leaking water in to the bowl, & I socially traced it to the flapper not always fortunately sealing. So I gone to Menard`s, was easily pre...
...t is good.
While I was at it, I gave the car a tune-up, including new wires, and clean-ed out the EGR valve.
Hopefully that will do it for a while and my teenager will be able to drive this car ...
I need to run an industrial strength hot water hose from my water heater presure relief valve to under the house for pressure relief drainage. I need approx. 6 FT of hose with 3/4" male connecto...
...lar hot water storage tank is building up pressures of 160 PSI on sunny days causing my 150 PSI pressure valve to drip. It didn't used to do that. What might cause this excessive pressure, and s...
...(approved for gas), not tape. Support pipe frequently. Use Black iron, not galv. Provide a shutoff valve (approved for gas) at the stove.
You should do a computation of the BTU requirements ...
...
1. Had water in gas
2. Fuel filter had been reversed
3. Broken lower O-ring on injector
4. Idle Air Valve corroded in place.
Fixing all the above (over a period of sessions) now have it running ...
...d out clean of gas before put away otherwise things get gummy and block the smallest orifices. ei. meter valve seats. Sounds logical to these ears.
Francis...
I'm looking to replace the gas valve in my furnace. It is a White-Rodgers model 36e93 type 303. In searching for one, I mostly find the 36e93-304. When comparing the two, everything seems to b...
...he back side of the wood stove. This coil connects to a cold water feed, circulator and pressure relief valve and then to the coil in the Burnham Boiler. I think it should work. Thanks for replying...
...strange creaking noises. The boiler broke last week and apparntly the plumber had to mess about with the valve on it. The landlord has said that it needs to be bled but for some reason he has to do it...
glow plug cycles off normally after a few sec. i would say thats not your concern. sounds gas valve not opening .sensors not detecting flame and cycles
off system. new starters are mostly glow plugs ...
... the other heater. Had trouble getting 24v off the transformer. I think we had one wire grounding to the valve wrong. Still no spark at the ignitor. Took it off and WALLA!!!. The electrode was too clo...
...t with specs, yet when hitting it with the light, and looping out the ECM the mark jumps eratically, the valve adjustments are in spec. Any suggestions would be helpful....
Drain your gas tank at the shut off valve. I had the same problem and there was water in the tank and at times it would migrate into the fuel line and cause a shutdown. Drain into a clear container an...
...you use a vacuum pump to evacuate (30 minutes) the system before refill?
Did you change the expansion valve/orifice tube?
What did the A/C mechanic say, or didn't this happen in his presenc...
...t can't compensate fast enough to keep idle up. You may also want to check for a slow reacting EGR valve. you can unplug the EGR solinoid to test that....
had heads rebuilt on a early eng 302 everthing went will until valve adjustment did by the book truck ran great for about 3min then they came out of adjustment 3min later while still running truck beg...
...ngine is bigger and the old radiator is designed for 1.8 non turbo engine...
or it might be the water valve that is blocking the water flow.. located near the exit of the engine hose returning to t...
Check the pickups in the tanks, and make sure there is no cracks in the lines from the tanks to the valve and pump. The smallest crack in that line will allow air to come in and kill the suction. al...
...- like $10.
Ihave made my own out od a gatorage bottle (wide bottom) and a vacuum line with a one way valve in the line.
If you need info on how to bleed properly with one or two people, i can g...
The Content on this site is provided for general information purposes only. Your use of the Content, or any part thereof, is made solely at Your own risk and responsibility. By entering this site you declare you read and agreed to its Terms, Rules & Privacy.
Copyright © 2006 - 2010 DIY Forums |
TIP: Write your question in details [ why? ]
Sponsored LinksLatest Posts
|
more posts...