Ask A Question
 
t047
Fresh Boarder
Blog Posts: 0
Forum Posts: 3
Rating: 0ApplaudCriticize
Posted 2 Years, 4 Months ago #1
Hi guys,
I want to increase the height of some of my components by 40-50mm Ive seen
some mounting screws but they are too small. Do any of you gous know where I could get this type of screw from. Basically you screw the bottom bit in, then the component goes on top then you screw the top screw in!
Thanks
Administrator
Administrator
Jeffie
Blog Posts: 0
Forum Posts: 1350
Rating: 17ApplaudCriticize
Posted 2 Years, 4 Months ago #2
Something like this maybe?

click here
t047
Fresh Boarder
Blog Posts: 0
Forum Posts: 3
Rating: 0ApplaudCriticize
Posted 2 Years, 4 Months ago #3
i think they are called jackscrews or standoffs
anyway thanks!
Administrator
Administrator
SWHouston
Blog Posts: 1
Forum Posts: 380
Rating: 11ApplaudCriticize
Posted 1 Year, 7 Months ago #4
This is a little late, but....

It's possible that this is a three part device.
The cap screw at the top,
the nut at center and
a thresdded stud screwed into the bottom.

The Nut part may be a "Coupling Nut, found at...
http://www.grainger.com/Grainger/wwg/guideBrowse.shtml

This item comes in SAE, USS an Metric in all thread diamenters. but in most instances, rather standard in length. One may use a Stud to combine two or more, to get an approprlate length.

Have a good Day !
S.W.
Good Golf, good DIY, and anything else that makes you happy!

Related Posts:

Spread the Word!

Four out of five users would recommend us to a friend. Shouldn't you?
Link to Us    Tell a Friend
The Content on this site is provided for general information purposes only. Your use of the Content, or any part thereof, is made solely at Your own risk and responsibility. By entering this site you declare you read and agreed to its Terms, Rules & Privacy.
Copyright © 2006 - 2010 DIY Forums